Basic Operations; Now You Can Play A Variety Of Discs; Overview Of The Two Play Modes; Triple Disc Tray Usage - JVC XL-MV757TN Instructions Manual

BASIC OPERATIONS

Now you can play a
variety of discs!!

Overview of the two play modes

The player has two play modes for Video CD and SVCD discs. These
are selected by the PLAY MODE switch on the left side of the front
panel.
NORMAL PBC OFF
NORMAL: Allows use of the Playback Control (PBC) function.
PBC OFF: Inhibits the PBC function.
It only affects Video CD and SVCD discs with PBC function.

Triple disc tray usage

Up to three discs can be loaded in the player. You may insert a disc into
any of the disc trays 1 through 3.
If you want to play only a specified disc, press the corresponding CD
1, 2 or 3 button located to the right of the 0 (OPEN/CLOSE) button.
When three discs are inserted, basic order of playing is as follows.
• Pressing CD 1: CD 1
• Pressing CD 2: CD 2
• Pressing CD 3: CD 3
CD
CD
CD
Page 6
CD 2 CD 3 STOP
CD 3 CD 1 STOP
CD 1 CD 2 STOP
PLAY & EXCHANGE

Display window

The display window indicates many aspects of control and operation
status.
1
Shows the disc number being played.
1
Shows mainly the total number of tracks and the track number being
2
played.
3 Mainly shows the cumulative time (minutes and seconds) of the
track when the player is playing. It also shows the total time of the
disc for about ten seconds after the player stops playback, or
finishes reading the disc information when a disc has been inserted.
Shows the type of disc being played.
4
Each indicator in this area lights when the corresponding function
5
is activated.

Preparation for playing

Turn on the television set, amplifier or receiver to which the player
3
CD
is connected. Then set the channel and modes properly to accept
2
the player's output signal.
CD
1
CD
CAUTION
Set the sound volume of the television set, amplifier or receiver
to which the player is connected to a reasonable level before
starting playback.
Press the POWER ON/OFF button.
Press the button on the front panel or the VCD
/
on remote control. The STANDBY indicator goes out.
STANDBY /ON
The display window shows the initial information as shown below.
4
2 5
POWER
ON OFF
VCD
TV
/
or
(Remote control)
3
(TV ) button
/ /
/
/