Care And Maintenance; Cleaning The Lens - JVC RV-NB10W Instructions Manual

8 B fo, tumi., o. system, p rep r
music source selected in step 6. on page
19.
TUNER:
TU=*TAPE:
CD:
TAPE:
Tune in to the desired frequency (FM/AM/
WIRELESS).
Time in to the frequency (FM/AM/
WIRELESS) you want to record. Insert a
cassette tape for recording.
Set a disc.
Insert a tape.
Notes:
• By using "WIRELESS," you can also record the sounds
through the auxiliary equipment connected to the wireless
transmitter.
. Listening to or recording auxiliary equipment connected to
the wireless transmitter, start playing the equipment before
the timer turns on.
Press ®aO./SVA.DeV te turne. the
system,
. When tile timer turns on, the volume
level gradually increases
from B (zero) to the preset level in step on page 19.
However, if the volume has been set to .... , the volume
level will be set to the last level directly.
To cancel the operation, press CLOCK/TIMER until the
display returns to the original one.
To cancel the timer, press CLOCK/TIMER once, then press
CANCEL. ("T1MEROFF" appears, only when power is on.)
To reactivate (or confirm) the canceled timer, press
CLOCK/TIMER once, then press SET. (The current timer setting
appears for confirmation.)
Notes:
. The timer cannot
be set if on-time and off-time are the same.
= The timer does not work if the system is not in tile standby mode
(tile system needs to be in standby mode at least one minute
before the on-time).
CAUTION: If memory backup batteries are
exhausted or not installed, and the AC power
cord is disconnected or there is a power failure,
time settings will be erased from memory, if this
happens, set the current time (clock) and
perform the timer setting again.
Care and maintenance
Handle your discs carefully, and they will last a long time.
Compact discs
DIGITAL AUDIO
x@
x@
• This system can play back the following discs:
Audio CD
Finalized CD-R/CD-RW recorded in audio
CD format or MP3 format
However, continued use of irregular shape
discs (heart-shape, octagonal, etc.) can damage
the system.
. Remove the disc from its case by holding it at
the edges while pressing the case's center hole
lightly.
* Do not touch the shiny surface of the disc, or
bend the disc.
= Put the disc back in its case after use to prevent
warping.
= Be careful not to scratch the surface of the disc
when placing it back in the case.
* Avoid exposure to direct sunlight, temperature
extremes, and moisture.
. A dirty disc may not play correctly. Ifa disc
does become dirty, wipe it with a soft cloth in a
straight line from center to edge.
CAUTION: Do not use any solvent (for example,
conventional record cleaner, spray thinner,
benzine, etc.) to clean a disc.
General notes
In general, you will have the best performance by keeping your
discs and the mechanism clean.
* Store discs in their cases, and keep them in cabinets or on shelves.
* Keep the disc compartment door closed when not in use.
Cleaning the lens
If tile lens in tile pickup is dirty, dropout, etc., could degrade sound.
Open the disc compartment door and clean the lens as shown.
= Use a blower (available at camera stores) to blow dust off the
lens.
Blower
' Lens
. If there are fingerprints, etc. on the lens, gently wipe clean with a
cotton swab.
Continued on tke next page...
2O