Frigidaire CGEF306TMFA Use & Care Manual page 24

SETTING OVEN CONTROLS
SETTING THE SABBATH FEATURE (for useon
theJewishSabbath & Holidays)
The BAKE TIME and DELAY START pads are used to
setthe Sabbathfeature. T he Sabbath feature may onlybe
used withthe BAKE pad. The oven temperaturemay be
sethigheror lowerafter setting t he Sabbath feature (the
oven temperatureadjustmentfeature shouldbe used only
during ]ewishHolidays), however thedisplaywill notvisibly
show or provide any audible tones indicating whether the
change occurred correctly. Once the oven is properly set
using Bake with the Sabbath feature active, the oven will
remain continuously ON until cancelled. This will override
the factory preset 6-Hour Energy Saving feature.
If the oven light will be needed during the Sabbath, press
OVEN LIGHT _ beforeactivating the Sabbath feature.
Once the oven light is turnedON and the Sabbath feature
isactive, t he oven light will remain ON until t he Sabbath
featureisturned OFF. Ifthe oven light needs to be OFF,
be sure to turn the oven light OFF beforeactivating the
Sabbath feature.
To Program the Oven to Begin Baking Immediately &
activatethe Sabbath feature (example: b akdng at350°F)
i. Be surethat the clock is setwiththecorrect timeofday.
2. Place the food inthe oven.
3. Press UPPER or LOWER to select oven.
4. Press BAKE. "350 °" appears in the display.
5. Press START. The actual oven temperature appears in
the display.
6. If you desire to set the oven control for a Bake Time
or Delayed Bake Time do so atthis time.Ifnot,skip
thisstep and continueto step 8. Referto the Bake
Time / Delay Start section f orcompleteinstructions.
Remember the oven will shut down after using Bake
Time or Delay Start and therefore m ay onlybe used
once during theSabbath!Jewish H olidays. The maximum
Delayed Start Bake time is 11 hours & 59 minutes.
7. The oven will turn ON and begin heating.
8. Pressandhold boththeBAKETIlEand DELAYSTART
pads for at least :3 seconds. "SAb" will appear in the
display. Once "SAb" appears in the display the oven
control will no longer beep or display any further changes
and the oven is properly set for the Sabbath feature.
9. The oven may be turned OFF at anytime by first pressing
CANCEL pad (this will turn the oven OFF only). To turn
OFF the Sabbath feature press and hold both the BAKE
TIME and DELAY START padsfor at least 3 seconds.
"SAb" will disappear from the display.
IMPORTANT
It is not advised to attempt to activate any other program
feature other than BARE while the Sabbath feature is
active. ONLY the following key pads will function after
setting the Sabbath feature; 0 to 9, BAKE, START &
CANCEL. Allother keypads shouldnot be used once
theSabbath feature isproperly activated.
24
NOTE
You may change the oven temperature once baking has
started by pressing BAKE, the numeric key pads for the
temperature you want (example for 425°F press 4 2 5)
and then pressing START twice (for 3ewish Holidays
only). Remember that the oven control will no longer
beep or display any further changes once the oven
is set for the Sabbath feature.
Should you experience a power failure or interruption, the
oven will shut off. When power is returned, "SF" (Sabbath
Failure) will be shown in the oven display and the cooktop
displays. The oven and cool<top will not turn back on
automatically. If your food was nearly fully cooked, you
may allowthe trapped heat in the oven to finish the cooking
process. Otherwise, you should remove the food when the
power failure occurs, because you may only start the oven
once during the Sabbath/Jewish Holidays. After the Sabbath
observance turn OFFthe Sabbath feature and the oven may
be used with all normal functions.
After the Sabbath observance turn OFFthe Sabbath feature.
Press and hold both the BAKE TIME and DELAY pads for at
least 3 seconds. "SAb" will d isappear from the display and
the oven may be used with all normal functions. For further
assistance, guidelines for proper usage, and a complete list
of models with the Sabbath feature, please visit the web at
http: \, _\www, sta r-k.org,
How the Electronic Surface Element Controls work
when the Sabbath feature is ON.
When your Oven Sabbath feature is ON, the Electronic
Surface Elements are also in Sabbath mode. This means
that all electronic surface element control displays show
"Sb". The surface elements can be used even if the Sabbath
Feature is on.
To turn ON a Surface Elementwhen the Oven Sa bbath
Feature is active:
If you turn on a surface element when the oven Sabbath
feature is on, the electronic surface element control will
record that request and execute it with a 15-30 seconds
delay. So the element will start heating 15-30 seconds
after the surface element control was turned on. As the
oven control, the surface element display will not show the
setting because "Sb" is on in the displays. When necessary,
it is possible to adjust the power of the surface element but
you have to remember that the surface element control will
adjust the temperature with the same delay.
To turn OFF the Surface Element when the Oven
Sabbath Mode is active:
To shut off the surface element while the Sabbath feature
is ON, proceed as usual but take note that the element will
immediately turn off without any delay.