Important Safety Instructions; Using The Air Conditioner; Air Conditioner Features - Kenmore Room Air Conditioners Owner's Manual

..... • ...... .
Using the Air Conditioner
NOTE: If the air conditioner is turned off,
wait 3 minutes before restarting This
allows pressure inside the compressor to
equalize Failure to follow these
instructions may cause inefficient
operation.
To reduce the risk of fire, electric shock, or injury to persons, read the
IMPORTANTSAFETYINSTRUCTIONS before operating this appliance
To begin operating the air conditioner, follow these steps:
I, Plug in the air conditioner (To prevent electrical hazards, do not usean extension
cord or an adapter plug.)
2. Set the exhaust vent to the CLOSEDposition
3, Set the TEMP Control to the coolest setting
4 Set the fan control at the highest level,
5 Adjust the louvers for comfortable air flow,
6. Once the room has cooled, set the fan to the POWERSAVERFAN setting and/
or adjust the TEMP Control to the setting you find most comfortable
Review the "Air Conditioner Features" section for other settings,
Air Conditioner Features
VENT
EXHAUST CLOSED
Kenmore
FAN
OFF
HIGH
/
MED. (i_
LOW
POWER
SAVER
HIGH
4
MED,
LOW
NORMAL
TEMP
COOLER
HEAVY DUTY
The controls featured in this manual are representational of the many models
available. Your model may took slightly different.
TEMP Control
TheTEMP Control servesasthe thermostat to set the degree of room coolness, Turn
the knob clockwise from thin rule to thick rule to increase the cooling temperature,
FILTER MONITOR (some models)
To check filter monitor:
1. Set NORMAL fan control to HIGH setting
2. If fitter needs cleaning, a RED indicator will appear in the filter monitor
window A clean filter will help reduce operating costs and increase cooling
efficiency
NORMAL Fan
When in the NORMAL Fan setting, the air conditioner runs all the time, circulating
the air, Cooling starts only if the room temperature rises above the coolness level
selected on the TEMP Control, and stops once the set coolness level is reached This
setting gives the most even room temperatures
POWER SAVER Fan (some models)
The POWERSAVERFan can save energy In this setting, the fan will not run unless
the TEMP Control isset colder than the room temperature, When the TEMPControl
is set colder than room temperature, the air conditioner will begin to circulate the
air in the room Cooling will begin in about 3 minutes, The air conditioner turns off
automatically when the room reaches the level of coolness selected, HIGHis for fast
cooling, MED is for normal cooling, and LOW is for quiet cooling
HEAT (some models)
The HEATselection provides quiet, efficient circulation of warm air, Turn the selector
to the HEATsetting and set the thermostat to the warmest setting, When the HEAT
COOL
OFF " .... :
•HIGH
LOW LOW
HEAT
HEATContro! (somemodels)
FAN TEMP
POWER NORMAL
SAVER OFF
HIGH _.. HIGH
MED. (_ j MED. IQ_ ii!'l,i)i:i::
LOW LOW
Side Air Model Control Panel
VENT
CLOSED
EXHAUST