Ice And Water - Jenn-Air JFD2589KES Use & Care Manual

I
CE AN D WATE R
15
Automatic Ice Maker
Connect the ice maker to the water supply as
instructed on pages 7-8. Proper water flow and a
level refrigerator are essential for optimal ice
maker performance.
Operating Instructions
• Confirm ice bin is in place and ice
maker arm IS down.
• After freezer section reaches
between 0 ° to 2° F (-18 ° to -17 ° C),
ice maker fills with water and
begms operatmg. You will have a
1111t1111111111
complete harvest of ice approximately every three
hours.
• Allow approximately 24 hours after installation to
receive first harvest of ice.
• Discard ice created within first 12 hoLirs of operation
to assure system is flushed of in]purities.
• Stop ice production by raising ice maker arm until
click is heard.
• Ice maker will remain in the off position until arm is
pushed down.
• The first one or two batches will probably contain
undersized and irregular cubes because of air in the
supply hne.
• When the ice cubes are ejected it is normal for
several cubes to be joined together at the ends. They
can easily be broken apart. The ice maker will
continue to make ice until the supply of ice cubes
raises the ice maker arm, shutting the ice maker off.
• Certain sounds may accompany the various cycles of
the ice maker. The motor may have a shght hun], the
cubes will rattle as they fall into an empty storage bm
and the water valve may click or "'buzz" occasionally.
• If the ice is not used freqLiently, the ice cubes will
become cloudy, shrink, stick together and taste stale.
Empty the ice storage bin periodically and wash it in
lukewarm water. Be sure to dry the bin thoroughly
before replacing it.
• Beverages and foods should not be placed in the
ice storage bm for quick chflhng. These items can
block the ice maker arm, causing the ice maker to
malfunction.
• Turn off (arm Lip) the ice maker when the water
supply m to be shut off for several hours.
To Remove the Ice Bin:
• Pull it forward, away from the ice maker. To avoid the
ice maker dun]ping ice while the bin is removed, turn
the ice maker off by raising the icemaker arm.
To Install the Ice Bin:
• Reverse the above procedure. Turn the ice maker on
by lowering the ice maker arm.
To avoid personal injury or property damage,
observe the following:
• Do not place fingers or hands on the automatic
ice making mechanism while the refrigerator is
plugged in. This will help protect you from possible
injury. It will also prevent interference with moving
parts of the ejector mechanmm and the heating
element that releases the cubes.
Under certain rare circumstances,
Ice
cubes may
be discolored, usually appearing with a green-
bluish hue. The cause of this unusual discoloration
can be a combination of factors such as certain
characteristics of local waters, household
plumbing and the accumulation of copper salts in
an inactive water supply line which feeds the ice
maker. Continued consumption of such discolored
ice cubes may be injurious to health. If such
discoloration is observed, discard the ice cubes
and contact your dealer to purchase and install a
water line filter.
Water damage due to improper water connection
may cause mold/mildew growth.
Clean up water and ice spills to avoid personal
injury and to prevent mold/mildew growth.
Water Dispenser
The Water Dispenser is located on the
left side wall of the fresh food section.
This design is for cold water
dispensing only.
To Dispense Water:
• Hold container under spout and
press dispenser pad.