Jenn-Air JWC2450ARW Owner's Manual page 11

2. Install the supplied lock body into the wood panel.
The lock and key assembly is supplied with your
wine chiller. Secure the lock body by using the
supplied 15 mm lock retaining nut and screwing it
on the lock body's threaded section. Make sure
that the lock's key slot is vertical, then tighten the
15 mm nut with a 15 mm deep-well socket.
body
Lock cam
Phillips
so rew
Lock
extension
Door
gasket
Lock retainer nut
3. Peel back door gasket on the ghss door to provide
access to the screw holes used to mount the
wooden frame and the hole for the lock's extension
section at the top of the door.
4. Place the custom wood panel on a non-abrasive
surface, protected by towels or rugs, to avoid
accidental damage to the door finish.
5. Set the wood frame fhsh to the front of the door in
the desired location clamp wood frame to the door
if necessary. Check to see that the back of the
lock in the wood frame lines up with the hole in
the door.
6. Insert the wood screws through the back of the
door into the pilot holes in the wood frame and
tighten.
7. Assemble the door lock Phillips screw, lock
extension, lock cam and mount them to the back of
the lock body. Position the door lock cam so that it
projects upward from the top of the door. Tighten
the Phillips screw to secure the lock assembly.
10.
11.
12.
13.
1/4.
Reinstall the door gasket by pressing into door
channel. Make certain the corners are inserted
fully. Insert the key into the lock and make sure
the lock operates properly.
Install the door to the wine chiller. Use the
washers (if provided) as shown on page 9.
Realigning the door may be necessary. Final door
adjustments can be made using a Y," Allen wrench
to adjust the door hinges ([see figure below).
Attach the door to the wine chiller by reversing
step number one above.
Make certain that the glass door swings freely, the
door gasket seals properly and the interior light
goes on and off as the door opens and closes.
Confirm that door lock turns a quarter turn from
vertical to horizontal and that this locks the door
closed.
Reconnect the power to the wine chiller. Return
the control knob to its previous setting.
Magnetic door gasket
%" ([1.0 cm)
_i-h clearance
oles for wood
r frame wood
screws
Rear of door
Not required
for 4" toe kick
_ Light door
'/_"Allen head screws for striker plate
hinge adjustment ([top
and bottom of door). _
IAttached
__/_J
h_ wood A \ Bottom of door
Frame
10