Wine Racks; Stocking The Wine Cellar - Jenn-Air JUW248LBRB00 Use & Care Manual

Wine cellar
Table of Contents

Advertisement

Available languages

Available languages

Adjusting Controls
The mid-setting
indicated in the previous section should be
correct for normal usage. The control is set correctly when
beverages are as cold as you like.
If you need to adjust the temperature,
wait at least 24 hours
between adjustments and then recheck the temperature.
To make the wine cellar colder, adjust the control to the next
higher setting. To make the wine cellar less cold, adjust the
control to the next lower setting.
Temperature
Separator
(Temperature
Display)
The temperature
separator displays the current temperatures
(Fahrenheit or Celsius) for the upper and lower zones
(compartments)
of the wine cellar. To adjust the temperature
settings, see "Adjusting Controls" earlier in this section.
!
A
B
C
D
A. Dimmer
B. Upper zone display
C. Lower zone display
D. Fahrenheit/Celsius
Recommended
Zone Storing
Locations
For best storing and serving temperatures
for your bottle of wine,
use the wine producer's
recommended
temperature
setting. See
the wine's label for details. It is recommended
to store wine for
short-term
(few months) at 55°F (13°C).
WINES
ZONES
White Wine
Upper zone
Lighter Red Wine
Lower zone
Red Wine
Lower zone
To Remove and Replace the Wine Racks
1. Pull the rack forward until it stops. Push in on the tabs to
release the rack. Continue pulling the rack forward and lift it
up and out of the rack supports.
A
f
2=
Replace the rack by inserting the rack into the supports and
sliding it toward the rear of the wine cellar.
\
\
\
To Remove
and Replace the Bottom Rack
1. Lift the rack (front and back) up and pull straight out to
remove.
2. Replace the rack by pushing it straight back and over the
stop. Continue pushing the rack straight back and evenly
until it is in place.
NOTE: For optimum wine storage, place white wines at the top of
the wine cellar, Light red wines in the center and red wines at the
bottom.
To Stock the Wine Cellar
1. Start stocking the wine cellar with the bottom display rack.
2. Starting on the left-hand side, place the first bottle on the
bottom of the rack with the neck of the bottle facing the back
of the wine cellar.
3. Place the next bottle on its side with the neck of the bottle
facing the front of the wine cellar.
4. Alternate in this manner until the display rack is full.
5. Pull the next rack forward.
A
A. Tabs
6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents