Start And Stop; Cold/Warm Engine Start - Husqvarna 125BT Operator's Manual

START AND STOP
Start and stop
WARNING!
Always move the machine from the filling
area before starting. Place the machine on
a flat surface. Make sure no unauthorised
persons are in the working area,
otherwise there is a risk of serious
personal injury. The safety distance is 10
metres.
Cold engine
IGNITION:
Set the stop switch to the
start position.
CHOKE:
Set the choke control in the
choke position.
AIR PURGE:
Press tile air pmge
diaphragm repeatedly until
fuel begins to fill the
diaphragm. The diaphragm
need no_ be completely
filled.
Warm engine
Use the same starting
procedure as for the cold
engine, but do not set the
choke control in tile choke
position. The start throttle
position is obtained by
setting the choke contrnI in
tbe choke position and then
returning it to its original
position.
Stop
The engine is stopped by
switching off"the ignition.
Start
Press the machine body
against the ground using
your left hand (NOTE! Not
your foot). Grip the starter
handle, slowly pull out the
cord with your right hand
until you feel some
resistance (the starter pawls
grip), now quickly and
powerfully pull the cord.
Reset the choke control as
soon as the engine fires and
repeat until the engine starts.
When the engine starts
quickly apply fllll throttle
and the start throttle will
automatically disengage.
NOTE! Do not puil the
starter cord out completely
and do not release the starter
cord from the fnlly extended
position. This can darnage
the machine.
"15 - English