This product is in accordance with applicable EC directives. Always wear approved protective gloves. Wear sturdy, non-slip boots. The blower can forcibly throw objects that can bounce back. This can result in serious eye injuries. The blower operator must ensure that no people or animals come closer than 10 metres.
It is extremely important that you read and understand the contents of this Operator’s manual. Husqvarna AB has a policy of continuous product development and therefore reserves the right to modify the design and appearance of products without prior notice.
SAFETY INSTRUCTIONS Personal protective equipment WARNING! You must use approved personal protective equipment whenever you use the machine. Personal protective equipment cannot eliminate the risk of injury but it will reduce the degree of injury if an accident does happen. Ask your dealer for help in choosing the right equipment.
SAFETY INSTRUCTIONS Vibration damping system Your machine is equipped with a vibration damping system that is designed to minimize vibration and make operation easier. The machine’s vibration damping system reduces the transfer of vibrations. WARNING! Overexposure to vibration can lead to circulatory damage or nerve damage in people who have impaired circulation.
HT lead are not damaged. Otherwise you could get an electric shock. The blower operator must ensure that no people or animals come closer than 10 metres. When several operators are working at the same site a safety distance of at least 10 metres must be in effect.
• Use the blower with the lowest possible throttle. It is seldom necessary to use full throttle, and many work procedures can be done at half throttle. A lower throttle means less noise and less dust, and it is also easier to keep control over the rubbish collected together/moved.
• Use a rake or a brush to release rubbish stuck to the ground. • Hold the opening of the blower as close to the ground as possible. • Observe your surroundings. If anyone approaches your work area, set the throttle control to the lowest throttle until the person is at a safe distance.
What is what? 1 Spark plug 2 Choke control 3 Air ﬁlter 4 Starter handle 5 Fuel tank 6 Harness 10 – English WHAT IS WHAT? 7 Mufﬂer 8 Blow pipe 9 Throttle control 10 Stop switch 11 Throttle adjuster 12 Operator ′...
Assembly of the blower 1 Connect the ﬂexible hose (A) to the fan’s outlet tube (B) with a hose clamp. 2 Connect the operating tube (C) to the ﬂexible hose with a hose clamp. 3 Fit the control handle (D) on the operating tube (C).
Mixture 1:50 (2%). • If HUSQVARNA two-stroke oil is not available, you may use another two-stroke oil of good quality that is intended for air cooled engines. Contact your dealer when selecting an oil.
STARTING AND STOPPING Starting and stopping WARNING! Always move the machine away from the refuelling area before starting. Place the machine on a ﬂat surface. Make sure no unauthorised persons are in the working area, otherwise there is a risk of serious personal injury.
Carburettor Your Husqvarna product has been designed and manufactured to speciﬁcations that reduce harmful emissions. After the engine has used 8-10 tanks of fuel the engine will be run-in. To ensure that it continues to run at peak performance and to minimise harmful exhaust emissions after...
See instructions under the heading Oiling the air ﬁlter. Oiling the air ﬁlter Always use HUSQVARNA ﬁlter oil, art. no. 531 00 92-48. The ﬁlter oil contains a solvent to make it spread evenly through the ﬁlter. You should therefore avoid skin contact.
Maintenance schedule Below you will ﬁnd some general maintenance instructions. If you need further information please contact your service workshop. Daily maintenance 1 Clean the outside of the machine. 2 Check that the throttle control functions safely. 3 Check that the stop switch works correctly. 4 Clean the air ﬁlter.
Technical data Technical data Engine Cylinder displacement, cm Cylinder bore, mm Stroke, mm Idle speed, rpm Recommended max. speed: Max. engine output, acc. to ISO 8893, kW/ rpm Catalytic converter mufﬂer Ignition system Type of ignition system Spark plug Electrode gap, mm Fuel and lubrication system Manufacturer/type of carburettor Fuel tank capacity, litre...
(Applies to Europe only) We, Husqvarna AB, S-561 82 Huskvarna, Sweden, tel: +46 36-146500, declare under sole responsibility that the blowers Husqvarna141B and 155 from 2000’s serial numbers and onwards (the year is clearly stated in plain text on the type plate with subsequent serial number), are in conformity with the following standards or other normative documents following the provisions in the COUNCIL’S DIRECTIVES:...
We, Husqvarna AB, S-561 82 Huskvarna, Sweden, tel: +46 36-146500, declare under sole responsibility that the blowers Husqvarna 125BT and 165BT from 2004’s serial numbers and onwards (the year is clearly stated in plain text on the type plate with subsequent serial number), are in conformity with the following standards or other normative documents following the provisions in the COUNCIL’S DIRECTIVES:...