Custom Control Switch - Hoover savvy Owner's Manual

Push screws into holes on back of
handle (Fig. 1-6) and hose holder
(Fig. 1-7).
Tighten screws securely with a
Phillips screwdriver.
Cleaner description
Place hose on holder.
Remove label (C) from Custom
Control
TM
switch.
If label has come off during
assembly, make sure switch is in
OFF (down) position before plug-
ging into electrical outlet.
16
20
17
The assembled cleaner will look like the drawing.
1. Handle
2. Custom Control
TM
power
switch
3. Custom Control
TM
indicator
4. Tool cover
5. Dusting brush
6. Powered hand tool
7. Furniture nozzle
8. Bag container
9. Bag container handle
10. Final filter
11. Three position handle
release pedal: step on
lever to lower handle to
operating or low positions.
12. Nozzle control knob:
slide knob to correct set-
ting for height of carpet
being cleaned.
13. Furniture guard
14. Headlight
15. Edge groomers
16. Hose
17. Carry handle/Hose
holder
18. Cord hooks: wrap
cord around hooks for
storage. The top hook
rotates right or left for
easy cord release.
19. Extension wand
20. Crevice wand: stores
in wand.
Operate cleaner only at voltage specified on data plate
on bottom of cleaner.
This cleaner is intended for household use.
Polarized plug
To reduce the risk of electric shock, this
appliance has a polarized plug (one
blade is wider than the other). This plug
will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install the
proper outlet. Do not change the plug in
any way.
Custom Control
TM
switch
Plug cord into electrical outlet.
CARPET setting - turns brush rolls ON
for cleaning carpets and rugs. (Brush
rolls will automatically stop turning when
handle is raised to upright position.)
BARE FLOOR setting - turns brush rolls
OFF for cleaning hard surface floors.
Brush roll automatic
shut-off
If something gets caught in the brush
rolls, the cleaner will automatically turn
off.
Slide the 'Custom Control' switch to OFE
Unplug the cleaner.
Remove obstruction from brush rolls and
continue cleaning.