Related Manuals for Hoover Wet/Dry Vac
Summary of Contents for Hoover Wet/Dry Vac
- Page 1 Wet/Dry Vac with Portable Blower and Exclusive two tank system Owner’s Manual Read these instructions before operating cleaner. ®...
-
Page 2: Table Of Contents
©1993 The Hoover Company www.hoovercompany.com Record and retain The HOOVER cleaner you have purchased is designed for both wet and dry pick up and also has a portable blower. The model and serial number are located on the portable blower. -
Page 3: Grounding Instructions
Questions or Concerns? The Hoover Company wants to quickly resolve any concerns about your cleaner or questions regarding its use. Look on the list provided with the product for your local Hoover Factory Service Center or in the Yellow Pages under “Vacuum Cleaners - Household”... -
Page 4: Assembly
1. Assembly Attach caster supports and casters Remove cleaner lid and inner tank. Turn outer tank upside down. Match letters (A or B) on bottom of caster supports with letters on cleaner tank. Then align square tabs (1) on supports with rails (2) on tank. Slide tabs onto rails until caster support (3) snaps in place. -
Page 5: Cleaner Description
Use squeegee for wet pick-up only. Additional tools and accessories that are not included with your model, are available at additional cost from your local Hoover Factory Service Center, Authorized Hoover Warranty Dealer, by using the enclosed order form or through The Hoover Company online at www.hoovercompany.com... -
Page 6: Automatic Wet Shut-Off
HOOVER® foam filter sleeve instead of the cartridge filter. See “Filters” in the Maintenance section for availability of HOOVER® filters. Automatic wet shut-off When either tank is full of liquid, the automatic shut-off mechanism will shut off cleaner pick-up. -
Page 7: Portable Blower
Drywall dust For best results when picking up dry wall dust, slide wet/dry selector (A) to expose “WET/TANK INLET” (B) and make sure no water or moisture is in the tank (outer tank). Keep inner tank in position. Insert hose into “WET TANK INLET” and attach desired tool to hose end. -
Page 8: Emptying Tank
(C). If the cleaner is used as a single tank unit for wet pick-up, it is best to use a HOOVER® foam filter sleeve, available at additional cost, instead of the cartridge filter. After wet pick-up Unscrew drain cap (A) from bottom of outer tank. -
Page 9: If You Have A Problem
• Automatic shut-off engaged. • See “Automatic wet shut-off” section Service To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot) by: • checking the Yellow Pages under “Vacuum Cleaners -... - Page 10 HOOVER et sont des marques déposées ® ® THE HOOVER COMPANY, NORTH CANTON, OHIO THE HOOVER COMPANY, NORTH CANTON, OHIO 44720 HOOVER and are registered trademarks ® THE HOOVER COMPANY, NORTH CANTON, OHIO 44720 3-98 S6760 Litho USA...