Carpet Height Adjustment; Custom Control™ Switch - Hoover UH40080 Owner's Manual

Custom Control™ switch
2.2
A
Transporting
cleaner
2.3
Put handle in
upright position .
Tilt cleaner back on
rear wheels . Push
forward .

Carpet height adjustment

2.6
D
C
Settings
For maximum cleaning performance, the
following carpet height settings are
recommended .
Low/Hard Surface: for bare floors and all
types of carpet
Note: If the cleaner is difficult to push, turn
knob to the next higher setting.
Actual model may vary from images shown.
Plug cord into electrical outlet .
CARPET setting - turns brushroll on, for cleaning carpets and rugs .
(Brushroll will automatically stop turning when handle is raised to
upright position .) BARE FLOOR setting - turns brushroll OFF for cleaning
hard surfact floors .
Brushroll automatic shut-off
If something gets caught in the brushroll, the cleaner will automatically
turn off . Slide the Custom Control™ switch to OFF . Unplug the cleaner .
Remove obstruction from brushroll and continue cleaning .
Carrying
cleaner
2.4
A
Use the carrying
handle to lift the
cleaner .
Do not lift cleaner
using dirt cup
handle (A).
The cleaning of
carpet and rugs
takes place at the
nozzle (C) .
When it is
necessary to raise
and lower the
nozzle for various
carpet pile heights,
turn the nozzle
control knob (D) to
the desired setting .
Handle positions
2.5
The handle of your cleaner has three
positions; upright for storage and when
using cleaning tools; operating position for
general operation on carpet and floors; low
for reaching under low furniture . Step on
handle release lever to lower handle .
Handle position
2.7
2.8
6
For ease in sliding
knob, place handle
in the upright
position and tilt
cleaner backward .
High Pile: for very
deep pile carpet
where easier
pushing effort is
desired, while
maintaining good
cleaning
performance .