Hoover SteamVac Owner's Manual page 4

The assembled cleaner will look like this
drawing (Ultra model shown).
3
A
Attach upper handle
[_ emove clean solution tank (upper
tank) from deep cleaner.
D ith cord hook (A) to back of deep
cleaner, push upper handle down onto
lower handle. Push bolts into holes on
front of handle. If bolts will not go
through hole easily handle is not pushed
completely down.
_ lace nuts in recessed areas on
back of handle. Hold each nut in
place while tightening each bolt securely
with a Phillips screw driver.
Only two nuts are needed on this model.
The extra nut is not required but has
been provided for your convenience.
W
B
LmJ_When handle sections are complete
ly together, squeeze trigger (B} or_
upper handle to snap trigger rod In
place.
M eplace clean solution tank (upper
tank} by positioning bottom first.
Press on tank handle to snap top of
tank into place.
I
..r
r
_ ress cord into cord clip on back of
handle. Pull cord tight.
Attach hose clip
PUSh tab on. side of clip into hole on
ide of handle.
_ ivot clip and push other tab into
hole at back of handle to lock into
place.