Advertisement
Select
tool
Your model includes some combination
of the following tools, but may not
include
them all.
G. SpinScrub
TM
hand tool has rotating
brushes for extra scrubbing action on
small carpet areas, carpeted
stairs and
upholstery.
H. Stair/upholstery
nozzle has a built-in
brush to help provide the scrubbing
action some spots may need for
removal.
I. Crevice tool can be used to clean
along edges of carpet, carpeted
stairs
and on upholstery.
How
to attach
tools
Unplug deep cleaner from electrical
outlet.
1. Place handle in upright position and
remove hose from rack.
All tools attach to the hose in the same
manner:
2. Connect tool to hose by sliding it onto
connector until the tab (J) locks it
securely.
Using your thumb, push forward
and
up on the latch (K) to remove tool.
After
using
tool
Drain suction hose by turning deep
cleaner ON and holding nozzle up for
several minutes. Do not press trigger.
Unplug deep cleaner from electrical
outlet.
Disconnect hose and solution
tube
from deep cleaner.
Drain solution tube by placing round
end in sink and raising nozzle above
your head. Press the trigger.
The tool caddy can be removed and
hung on a coat hanger for storage.
Read "Before
you begin cleaning"
instructions on page 10.
1. Attach hose and solution tube as
instructed in Figs. 3-11 to 3-13.
2. Place handle in upright position.
Agitator brushes will not rotate while
handle is in upright position.
3. Fill clean water tank according
to
instructions for Figs. 2-9 to 2-12.
4. FiN detergent container with HOOVER
Carpet/Upholstery
Detergent according
to instructions for Figs 2-13 to 2-15.
5. Attach tool to end of hose.
6. Hose length may require that
machine be placed at the top of the
stairs to clean upper half of stairway
and at bottom of stairs to clean lower
half.
To prevent machine from falling,
use
extra caution when cleaning on stairs.
Do not place deep cleaner on stairs.
Do not point tools toward
people or
pets.
7. Dry hands and plug deep cleaner
into a properly grounded outlet.
8. Set Rinse Setting switch to WASH-
AutoRinse. Turn cleaner ON.
Note: "Auto-rinse" and rinse are not
available during tool use. The hose will
only dispense water mixed with deter-
gent.
A
9. Pre-spray the carpeted stair by hold-
ing the tool (A) or (B) about one inch
above the carpet and push it forward
while pressing the trigger (equals one
wet stroke).
10. Position tool against the riser and slightly
press it into carpet pile. Press the trigger
and pull the tool slowly over the carpet
(second wet stroke). Release trigger at end
of stroke.
Continued
-_
13
Advertisement
