Spinscrub Mode Selector - Hoover SteamVac F7412-900 Owner's Manual

ON/OFF switch
Transporting
To turn cleaner ON,
push switch down.
To turn cleaner
OFF, push switch
up.
Handle release pedal
A
Step on pedal {A)
to lower handle to
operating posi-
tion. Handle does
not ]ock into a
single position but
"floats" to allow
convenient
opera-
tion.
El-
To move your
cleaner from room
tO room, put handle
in upright and
locked position,
tilt cleaner back on
wheels and push
forward.
Carrying handle
The cleaner may
also be lifted by
placing a hand
above the upper
clean solution tank
handle as shown.
SpinScrub mode selector
Your SteamVac"
cleaner has three agi-
tator brush settings.
SP1LL P1CK-UP -
brushes OFF for pick-
ing up spills or clean-
ing carpets and hard
floors when brushing
is not desired.
GENTLE SCRUB - for
delicate carpets and throw rugs
POWER SCRUB - brushes at maximum speed
for cleaning carpets. Slide setting selector to
the desired setting before cleaning.
ON [ OFF - Turns brushs on or off. Pretty
self explanatory.
Rinsesetting switch
Use this switch to se-
lect a wash with rinse
setting or a rinse only
setting.
WASH-AutoRinse"
[optional) - This
setting cleans your
carpet with detergent
and water on the
forward stroke. On the
reverse stroke, a water-only rinse is applied
to the carpet.
WASH- This setting applies water and deter-
gent for cleaning.
RINSE - This setting applies water-only rinse
in both the forward and reverse strokes.
See "How to clean" section for more
details.
Note: "Auto-rinse" and rinse are not avail-
able during tool use. The hose will only
dispense water mixed with detergent.
Wash/Rinse switch
For machines that do not have Auto Rinse"
This switch allows you to easily change from
clcaningyour
carpet or floor with a deter-
gent/water mix to rinsing with water only.
Www,]loover, eom
10