Advertisement
B
D
B
To replace
brushes
Align posts (A) on both ends of brush
assembly with slots (B) in cleaner hous-
ing.
Make sure that the square post (C) also
aligns with the square hole (D). Turn
brushes slightly until post fits easily into
hole.
Press brush assembly firmly to snap into
place.
Storage
Before storing:
• Empty clean water tank and let air
dry. Replace on deep cleaner.
• Unused detergent can be stored in
the detergent container.
• Empty recovery tank, rinse tank
and lid thoroughly with clean water
and let air dry.
Allow brushes and underside of deep
cleaner to air dry thoroughly before
storing deep cleaner on a carpeted or
wood
surface.
Do not store deep cleaner with a full
clean water tank in place.
Lubrication
The motor is equipped with bearings
which contain sufficient lubrication
for
the life of the motor. The addition of
lubricant could cause damage. Do not
add lubricant
to motor bearings.
If a minor problem occurs, it usually can
be solved quite easily when the cause is
found by using the check list below.
Possible cause
Possible solution
• Not firmly plugged in
• Plug unit in firmly
• No voltage in wall receptacle
• Check fuse or breaker
• Blown fuse/tripped
breaker
• Replace fuse/reset breaker
Possible cause
Possible solution
• Recovery tank full/automatic
shut
off engaged
• Remove and empty recovery tank
• Blockage in tool on end of hose
• Remove tool and clear blockage
• Recovery tank lid not on correctly
• MaRe sure lid is on securely
• Water tank empty, but detergent
remains
• Fill water tank
Possible cause
PosstT_/e soluhon
• Clean water tank not firmly
in place
• Make sure tank is securely locked in
position
• Clean water tank or detergent
container empty
• RefiT/container
accordlbg to instruc-
tions for surface being cleaned
• Recovery tank lid not on
correctly
• Make sure lid is
firmly
in place
Possible cause
Possible solu#bn
• Valve cap clogged
• Remove and clean valve cap (see fob
lowing instructions)
1. Remove clean water tank.
3. Align slots (B) on cap with tabs (C) in
opening.
Turn cap clockwise to tighten.
Possible cause
Possible soluhbn
• Dirty filter screen on bottom of unit
• Clean screen as shown in Fig 3-2
• Setting selector on OFF
• Move setting selector to ON
2. Turn valve cap (A) counterclockwise
and remove.
Soak valve cap in warm water for at
least 15 minutes. Wipe cap dry.
Continued
._
15
Advertisement
