Hoover SteamVac Owner's Manual page 4

!
Press cord into cord clip on back of handle.
Pull cord tight
(Fig, 8),
Attach
lower hose holder
(some models only)
HOSE
HOLDER
I
jJ
With front of deep cleaner resting on floor, place 2 projections
on lower hose holder into 2 holes on back of cleaner (Fig 9).
Push screw into hole and tighten securely with a Phillips screw
driver (Fig 10),
Storing hose and nozzle on rack
(some models only)
Stretch hose out and identify ends.
Note: You
may find it helpful when storing the hose and nozzle
to refer to the
information on the back of the deep cleaner
and on the converter end of the hose (Fig. 11).
4 Assembly
HANDLE
NOZZLE
CONNECTOR
HOOK
CLIP 1
To store hose on rack, begin by placing
nozzle connector end
of hose (straight end) into clip 1 on rack (Fig 12).
Secure hose to rack at numbered locations as shown.
(Fig. 13)
ALIGN ARROW
& HOOK FOR
CONVERTER
STORAGE
Converter is stored in area as
shown.
While aligning arrows (Fig.
14),
place extension into bottom of
converter opening; then push converter firmly against deep
cleaner until it snaps into place.
To remove, first pull top of converter off extension then pull off
bottom.
Secure solution hose to converter as shown.