Gas Connection - Hamilton Beach OG02 Assembly & Operation Manual

GAS CONNECTION
ONLY USE THE REGULATOR AND HOSE ASSEMBLY PROVIDED WiTH THiS
GRILL. REPLACEMENT PRESSURE REGULATORS AND HOSE ASSEMBLIES
MUST BE THOSE SUPPLIED BY THE MANUFACTURER.
This is an LP (Liquefied Petroleum Gas) configured grill. Do not attempt to use a natural gas
supply unless the grill has been reconfigured for natural gas use.
The installation of this appliance must conform with local codes or, in the absence of local
codes, with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or CAN/CSA B149.1,
Natural Gas and Propane Installation Code, or CAN/CSA B149.2, Propane Storage and
Handling Code.
LP TANK REQUIREMENTS -
THE LP TANK USED WiTH YOUR GRILL MUST MEET THE FOLLOWING:
1, Measurement: 12" (30.5=cm) diameter x 18" (45.7-cm) tall.
2. Maximum capacity: 20 Ibs. (9 kg).
3, Constructed and marked in accordance with the specification for LP gas tanks of the U.S.
Department of Transportation (DOT) or the National Standard of Canada, CAN/CSA-B339,
Tanks, Spheres, and Tubes for the Transportation of Dangerous Goods. See LP tank collar
for marking.
4, Tank must be oriented to provide proper vapor withdrawal, as shown in Fig, 14.
5. Includes a collar to protect the tank valve.
6, Has no dents or rust. A dented or rusty LP tank may be hazardous and should be checked
by your supplier.
7, Provides a shut=off valve terminating in an LP gas tank valve outlet specified, as applicable,
for connection type QCC1 in the standard for compressed gas tank valve outlet and inlet
connection ANSI/CGA V-l.
8, Other tanks may be acceptable for use with your grill provided they are compatible with the
tank retention means shown in Fig, 14.
LP TANK VALVE USED MUST MEET THE FOLLOWING:
1, Have type I outlet compatible with regulator provided.
2. Have safety relief valve.
3. UL=listed Overfill Protection Device (OPD). This OPD safety feature is identified by a unique
triangular hand wheel. Only use tanks equipped with this type of valve (as the figure shown
on the next page).
FOR YOUR SAFETY:
Ensure that the black plastic grommets of the regulator provided are in place and that the hose
does not come into contact with the heat shield or the grill head.
28