Unpacking Your Wine Cellar; Leveling Your Wine Cellar; Proper Air Circulation - Haier HVFM122A User Manual

Unpacking
Your Wine Cellar
1. Remove all packaging material, This includes the foam base and all
adhesive tape holding the wine cellar accessories inside and outside,
2, inspect and remove any remaining packaging, tape or printed
materials before powering on the wine cellar,
Leveling Your Wine Cellar
• Your wine cellar has four leveling legs which are located in the front and
rear corners of your wine cellar. After properly placing your wine cellar
in its final position, you can level your wine cellar.
• Leveling legs can be adjusted by turning them clockwise to raise your
wine cellar or by turning them counterclockwise to lower your wine
cellar. The wine cellar door will close easier when the leveling legs are
extended.
Proper Air Circulation
• To assure your wine cellar works at the maximum efficiency it was
designed for, you should install it in a location where there is proper air
circulation, plumbing and electrical connections,
• The following are recommended clearances around the wine cellar:
Sides ............... 2 "(50mm)
Top .................... 2" (50ram)
Back .................. 2" (50ram)
Door Hand_ Jn$taHation (Models: HVFMIO2ABL & HVFM122ABL)
• Unpack handle from its original packing, Holding the handle towards
you, align handle bracket holes with holes on the left hand side of the
door frame, Secure the handle to the door with the 4 supplied screws,