Haier HLF103Q User Manual page 24

4oW_r÷ Cord ConnecNons
drain relief
mounting bracket
1 • Remove the screws securing the terminal block access cover
and the strain relief mounting bracket located on the back
of the dryer upper corner.
2 Install a U J_. approved strain retief into the power cord entry hote
of the mounting bracket Finger tighten the nut
oilily
at this time.
3. Remove the green neut_'al ground whe from the green ground
screw located above the t_rminat block.
]typical
Condudcor _
Receptacle
black 240V
Typical
4 Conductor -_
Cord
green ground
so _Mp NEr_ _44o T'ZPE S eDT ORa Circuit
23