Haier HLF103Q User Manual page 10

3. Press "Sensor Dry Level" button to select a suitable drying time
,, After powering on, the clothes dryer automatically sets dryness at "very",
which means a longer drying time. If other drying time is desired, press
"Sensor Dry Level" button to select a shorter time.
4, Press "Temp" button to set a suitable drying temperature
,, After switching on, the dryer sets corresponding temperature adapting to
different program selected. If other drying temperature is wanted, press
"Temp" button to enable such a selection.
5, Press "Signal" button, you will be reminded up upon
end of a cycle
,, After switching on, the dryer automatically sets buzzer at "Softer", while the
user may define three prompt sound conditions "Louder", "Softer" and "Off".
6, Press "Wrinkle Saver"button to select a suitable reserved drying
program
After powering on, the dryer delay start drying program automatically sets as disabled.
When you desire a drying cycle ends at a delay time, press "Wrinkle Saver" button to
set wrinkle saver drying program. After initial pressing, the nixie display indicates 3 hrs,
which will be increased until 24 hrs by an increment 1 hr with every pressing. Pressagain
will display drying time. Here if press again, it will repeat from 3 hrs. if keep pressed for
1.5 s, nixie display will increase continuously.
• When"Wrinkle Saver" is enabled, your selected program indicator turns off while
"Wrinkle Saver"indicator and remaining reservation time indication turn on. During
reserved period, pressing "Wrinkle Saver" button can indicate reserve status.
To change operating program or cancel delay, you should cut off the supply and
re-select.
7, Press "Touch Up" button to select wrinkle-proof drying mode
Use the"Touch Up" cycle to complete drying if clothes are still damp after the
Automatic cycle.
* You can also use the"Touch Up" cycle to remove wrinkles from clean clothes
which packed tightly in a suitcase or closet.
8, Press "Start/Pause" button
If starting the machine, firstly close the front door and then press this button.
If pause is needed during machine operating, press this button. Pressing again will
resume operation.