Installationinstructions; Unpacking Your Dryer - Haier HLF103Q User Manual

Installation Instructions
Select a suitable location for the dryer on a hard even surface away from direct
sunlight or heat source e,g, radiators, baseboard healers, cooing appliances etc.
Any floor unevenness should be corrected with the leveling legs located on the
bottom of the dryer.
TooJs
and Paaterials Required
, Phillips head and fiathead screwdrivers
- CharmeFIock adjus_ble pliers
- 1/2 inch open end wrencls
, Carper_er_ level
• Measuring tape (12ft. rain.)
Duct tape
• Rigid or flexible metal 4 inch (10.2 cm) duct
, Vent hood
EJec_r_ca[ Requirement.s
Power Supply:
3 or 4 wire, 240 VotL 30 Amp, 60Hz, 1 Phase
Power Supp|y Cord Kit= (not supphed when sold m the United Sta_es)
[he dryeJ MIJST emplr_y a 3 conductor po_._er supply cord NEMA 10 30
type SRD] rated at 240 Volt AC minimum 30 Amp,, wtlh 3 open end
spade lug connectors with upturned ends or closed loop oonnecl.o[s and
marked for use with clothes dryers, if being installed in a manufactured
(mobile) home, the dryer MUST employ a 4Conductor power supply cord
NEMA 14-30 type SRDT or ST (as required) raled at 240 VoBt AC
minimum 30 Amp,, with 4 open end spade lug conr_ctors with
uptamed ends or clcead loop connectors and marked for use with clothes
dryels. See Eleclrtcal Conr_clJons for A 4-Wire System.
Unpacking rYour
Dryer
1. Remove all packaging material. 1"his includes the foam base and all
adhesive tape holding the dryer accessories inside and ouLside.
2. Inspect and remove any remains d packaging, tape Or p_inted
materials before using the dryer.
1 5