FujiFilm FINEPIX XP50 Series Owner's Manual page 7

J
• Do not mix old and new batteries, batteries
with different charge levels, or batteries of
different types
• If the camera will not be used for an extend
ed period, remove the batteries Note that
the calr'era clock will be reset
• Tile batteries may be warm to the touch
immediately after use. Turn the camera
off and allow the batteries to cool before
handling
• Battery capacity tends to decrease at low
temperatures Keep spare batteries in a
pocket or other warm place and exd/ange
as necessary Cold batteries may recover
so/r'e of their charge when warmed
• Fingerprints and other stains oil the battery
terminals can impair battery performance
Thoroughly clean tile teriHnals with a
soft, dry cloth before inserting them in the
camera
If the batteries leak, dean the battery
co/r'partlr'ent thoroughly before in
serting new batteries
If fluid from tile battery comes into
contact with skin or clothing, flush
the affected area with water If fluid
enters Vour eyes, immediately flush the
affected area with water and seek
medicalattention. Donotruhyoureyes.
Failure to observe thJsprecaution could
result in permanent visual impairment
• NiMH Batteries
The capacity of Ni MH batteries may be
temporarily reduced when new, after long
periods of disuse, or if they are repeatedly
recharged before being tully discharged. This
is normal and does not indicate a maltunc
tion Capacity can be increased by repeatedly
discharging tile batteries using tile discharge
option in the camera setup menu and re
charging them using a battery charger
(!} CAUTION: Do not use tile discharge option
with alkaline batteries
The camera draws a aft'all amount of current
even when off Ni MH batteries that have
been left in tile calr'era for an extended pe
riod may be drawn down to the point that
they no longer hold a charge Battery perfor
mance may also @op if the batteries are run
down in a device such as a flashlight Use tile
discharge option in tile camera setup menu
to discharge Ni MH batteries. Batteries that
no longer hold a charge even after repeat
edly being discharged and recharged have
reached tile end of their service life and must
be replaced.
Ni MH batteries can be recharged in a bat
tery charger (sold separately) Batteries ir'ay
beco/r'e warm to the touch after charging
Refer to the instructions provided with tile
charger for mote information. Use the char
ger with compatible batteries only
Ni MH batteries gradually lose their charge
when not in use
This section applies to all camera models
Use only FUJIFILM AC power adapters desig
nated for use with this camera Other adapt
era could damage tile camera
• The AC power adapter is for indoor use only.
• Be sure the DC plug is securely connected
to the cant'era
• Turn the camera off before disconnecting
the adapter. Disconnect tile adapter by the
plug, not the cable
• Do not use with other devices
• Do not disassemble
• Do not expose to high heat and humidity
• Do not subject to strong physical shocks
• The adapter may hulr" or become hot to the
touch during use This is normal.
• If the adapter causes radio interference,
reorient or relocate the receiving antenna
• Disposal
Dispose of used batteries in accord with local
regulations
vii