FujiFilm FINEPIX XP50 Series Owner's Manual page 3

Outdoor Antenna Grounding: If an outside
antenna or cable system is connected to the
video product, be sure the antenna or cable
system is grounded so as to provide some
protection against voltage surges and built
up static charges Section 810 of the NatiorM
Electrical Code, ANSWNFPA No 70, provides
information with respect to proper ground
ing of the mast and supporting structure,
grounding of the lead in wire to an antenna
discharge unit, size of grounding conductors,
location of antenna discharge unit, connec
tion to grounding electrodes, and require
ments for the grounding electrode
EXAMPLE OF ANTENNA _f{OUNDINd AS PE_
NATIOhlAL ELE_I R/CAL CODE
@ound(/amp _ Antenna Lead
_u,r_m_nt; " _1 _isch_g+Unr
I U_,- (NECSECTION
_ @ounding
f Conductors
Po,,v_'r Servl_ e @ouncDng
Electrode System (NECART (hlEC SECTION
2_0 PARTH) 81021)
Rower lines: An outside antenna system
should not be located in the vicinity of over
head power lines or other electric light or
power circuits, or where it can fan into such
power lines or circuits When installing an
outside arcenna system, extreme care should
be taken to keep from touching such power
lines or circuits as contact with them might
be fatal
Cleaning: Unplug this video product from the
wall outlet before cleaning Do not use liq
uid cleaners or aerosol cleaners Use a damp
cloth Br cleaning
Object and Liquid Entry: Never push objects
of any kind into this video product through
openings as they may touch dangerous volt
age points or short out parts that could result
in a fire or electric shock Never spill liquid
of any kind on the video product (excluding
waterproof products)
Lightning: For added protection for this video
product receiver during a lightning storm, or
whorl it is left urlattended and unused for long
periods of time, unplug it from the wall outlet
and disconnect the antenna or cable system.
This will prevent damage to the video product
due to lightning and power line surges
Servicing: Do not attem pt to service this video
product yourself as opening or removing coy
ers may expose you to dangerous voltage or
other hazards Refer all servicing to qualified
service personnel
Damage Requiring Service; Unplug this video
product from the wall outlet and refer servic
fng to quaNfled service personnd under the
following conditions:
• When the power supply cord or plug is
damaged.
• If liquid has been spilled, or objects have
fallen into the video product
• If the video product has been exposed to
rain or water (excluding waterproof prod
ucts)
• If the video product has been dropped or
the cabinet has been damaged
:) /0 "
If the video product does not operate nor
ma/y follow the operating instructions. Ad
iust only those controls that are covered by
the operating instructions as an improper
adjustment of other controls may result in
damage and will often require extensive work
by a qualified technician to restore the video
product to its normal operation
When the video product exhibits a distinct
change in performance this indicates a
need for service
Replacement Parts: When replacement parts
are required, be sure the service technician
has used replacement parts specified by the
manufacturer or have the same characteris
tics as the original part Unauthorized sub
stitutions may result in fire, electric shock or
other hazards
Safety Check: Upon completion of any service
or repairs to this video product, ask the ser
vice technician to perform safety checks to
determine that the video product is in proper
operating condition
///