How To Clean Tools - Hoover UH40155 Owner's Manual

Remove hose
When using clean-
ing tools, cleaner
handle should be
in the upright
position. Also, turn
cleaner OFF before
disconnecting and
connecting the
hose {A).
Remove hose end
from cleaner base.
Attach wand and tools
The tools are attached to the hose or the
wand in the same manner.
Push tool firmly onto hose; twist tool
stightly to tighten or loosen connection.
Attach second wand or tool to the wand in
the same manner.
Replacing hose
When you are
finished cleaning
with the tools, use
the end of the hose
to push the cover
(A) down and push
hose onto opening.
Twist hose end
slightly to tighten
the connector.
Extra reach hose
(available at additional cost]
The extra reach hose provides easier clean-
ing of stairs and hard to reach places. Follow
the steps below for attaching and detaching
hose.
Turn" cleaner OFF before disconnecting and
connecting hose.
Remove hose end from cleaner base.
Align end of extra reach hose with projec-
tions (A) with slots (B} on end of attached
hose.
Slide hose into slots and twist hose to lock it
into place. (To detach hose, reverse proce-
dure.)
Attach wands or tools to the other end of
hose.
How to clean tools
To clean the hose, wipe off dirt with a cloth
dampened in a mild detergent. Rinse with a
damp cloth.
Cleaning tools may he washed in warm water
with a detergent. Rinse and air dry before
using. Tools should be completely dry before
using again.