Hoover SteamVac F7428-900 Owner's Manual page 5

iSlil
Rotate t opofcaddy toward cleaner
handle. Slide caddy down sonotch (G)
oncaddy rests inhook (H)oncleaner,
Identify t hehose parts before s toring
hose.
I. Nozzle c onnector end
J. Solution tube
Storing hose and
tools
Press hose, a few inches from nozzle
connector end (I), into caddy. Bring
hose up and over top of caddy.
Press hose into opposite side of caddy.
Loop hose at bottom of cleaner and
press into top of hook (K).
Loop hose over top of caddy again.
Slide hose clip (L) toward end of hose.
Snap tab (M) on hose connector into
hose clip.
Repeat on other end of hose.
Press solution tube (.J) into opposite side
of clip.
Snap stair/upholstery nozzle onto
caddy.
Insert top of bare floor tool (available at
additional cost if not included with your
cleaner) through "loop" on caddy. Slide
tool down into place.
SpinScrub
TM
hand tool
(not included with all models)
The SpinScrub
TM
hand tool is shipped in
a plastic bag for protection. To remove
the bag before using the tool, open tool
door.
Continued -_
5