Advertisement
Storage
Before storing:
, Empty clean water tank and let air
dry. Replace on carpet cleaner.
, Unused detergent can be stored in
the detergent container.
, Empty recovery tank, rinse tank
and lid thoroughly with clean water
and let air dry.
Allow brushes and underside of car=
pet cleaner to air dry thoroughly
before storing carpet cleaner on a car=
peted or wood surface.
Do not store carpet cleaner with a full
clean water tank in place.
Lubrication
The motor is equipped with bearings
which contain sufficient lubrication for
the life of the motor. The addition of
lubricant could cause damage. Do not
add lubricant to motor bearings.
If a minor problem occurs, it usually can
be solved quite easily when the cause is
found by using the check list below.
Possible cause
Po.ssible solution
• Not firmly plugged in
• Plug unit in firmly
• No voltage in wall receptacle
• Check ruse or breaker
• Blown fuse/tripped breaker
• Replace fuse/reset breaker
Possible cause
Possible solution
• Recovery tank full/automatic
shut
off engaged
• Remove and empty recovery tank
• Blockage in tool on end of hose
• Remove tool and clear blockage
• Recovery tank lid not on correctly
• Make .sure lid is on .securely
• Water tank empty, but detergent
remains
• Fill water tank
Possible cause
Possible solution
• Clean water tank not firmly in place
• Make sure tank is .securely locked in
position
• Clean water tank or detergent
contai ner em pty
• Refill container according to instruc-
tions for surface being cleaned
• Recovery tank lid not on
correctly
• Make .sure lid is firmly in place
Possible cause
Possible solution
• Valve cap clogged
• Remove and clean valve cap (see tot-
lowing instructions)
1. Remove clean water tank.
3. Align slots (B) on cap with tabs (C) in
opening.
Turn cap clockwise to tighten.
Possible cause
Possible solution
• Dirty filter screen on bottom of unit
• Clean screen as shown in Fig. 3-2
• SpinScrub mode selector on SPILL
PICK-UP.
• Slide mode selector to GENTLE
SCRUB or POWFR SCRUB.
16
2. Turn valve cap (A) counterclockwise
and remove.
Soak valve cap in warm water for at
least 15 minutes. Wipe cap dry.
Hide quick links:
Advertisement
