Hitachi P50S601 Operating Manual page 6

AC CORD AND POWER SWIVEL CABLE iNSTALLATION iNSTRUCTiON
The AC cord and power swivel cable provided with your new Plasma Television need to be installed correctly
to avoid their disconnection when rotating the TV on its Table top stand.
Located on the back of the TV are 2 plastic clamps to hold the AC cord and power swivel cable. Please follow
the instructions below.
O
O
O
Pass the AC cord through Clamp #1 and connect
it to the TV. Pull on the clamp to tighten the
AC cord to the TV.
Connect power swivel cable on one end to the
swivel slot of the Plasma Rear Panel. Connect
the other end to the swivel slot of the Table
Top Stand Base.
The AC cord, power swivel cable and the signal
cables can all be held together with Clamp #2
(included on the accesories bag).
O Clamp #1 : Pass theAC cord through this clamp ;
then pull the clamp to tighten the AC
cord to the TV.
O Swivel on Top
slot
Table
Stand Base.
/
AC CORD
O Swivel slot on Plasma Rear Panel.
O Clamp #2: Use this clamp to hold the AC cord,
power
swivel connector and the signal cables.
Please assemble this Clamp on the middle
hole of the base metal.