Hitachi P50S601 Operating Manual page 27

OPERATING THE PRECODED
FUNCTION FOR YOUR CABLE BOX,
This remote is designed to operate different types of
cable boxes. You must first program the remote to
match the remote system of your cable box (refer to
pages 32-33 for pre-codes).
1.
2.
Turn ON your cable box.
To switch to Cable (CBL) pre-coded mode, use the
SOURCE SELECT button on the remote control
to position the LED light to the corresponding
selection SAT/CBL.
Hold down the SOURCE SELECT button on the
remote and enter the four digit preset code that
matches your cable box as shown on pages 32-33.
Release the SOURCE SELECT button. The indicator
light will flash 3 times if the code was accepted.
Aim the remote at the cable box and press the
POWER button. The remote will turn off your cable
box when the correct four digit preset code is
entered. When this occurs, the remote control is
programmed for your cable box. If the cable box
does not turn off, try a different four digit preset
code.
5. The remote will now control your Cable box.
m
@
(2>-__
@m
@
SOURCE SELECT
®®®
",i
,, ',
HITACHI
@
@ PRECODED CABLE BOX buttons
These buttons transmit the chosen precoded cable
codes :
-Power -Cursor & Select -Number PAD
-Menu -Info -Enter
-Exit -Channel Up & Down
-Guide -Last CH
(_) EXCLUSIVE TV buttons
These buttons are for operating the TV :
-Day/Night -CC -Inputs (only if
-Aspect -Vol Up & Down programmed, refer
-ANT -Mute to page 31 )
MY CABLE BOX CODE IS:
27