Hitachi P50S601 Operating Manual page 28

OPERATING THE PRECODED FUNCTION FOR
YOUR SET-TOP-BOX/SATELLITE RECEIVER.
This remote is designed to operate different types of
set-top-box/satellite systems. You must first program
the remote to match the remote system of your set-
top-box/satellite systems (refer to pages 32-33 for pre-
codes).
1.
2.
5.
Turn ON your set-top-box/satellite systems.
To switch to set-top-box/satellite (SAT) pre-coded
mode, use the SOURCE SELECT button on the
remote control to position the LED light to the
corresponding selection SAT/CBL
Hold down the SOURCE SELECT button on the
remote and enter the four digit preset code that matches
your set- top-box/satellite receiver as shown on page
32-33. Release the SOURCE SELECT button. The
indicator light will flash 3 times if the code was accepted.
Aim the remote at the set-top-box/satellite receiver
and press the POWER button. The remote will turn
off your set-top-box/satellite receiver when the
correct four digit preset code is entered. When this
occurs, the remote control is programmed for your
set-top-box/satellite receiver. If the set-top-
box/satellite receiver does not turn off, try a
different four digit preset code.
The remote will now control your set-top-box/
satellite receiver.
@
@---
@
@.._..
SOURCESELECT
®®®®
,i '_lj i
, ii " I_i PAdr
I
, ',
;,
HITACHI
@
@
O PRECODED SET-TOP-BOX/SATELLITE
RECEIVER buttons
These buttons transmit the chosen pre-coded
set-top-box/satellite codes :
-Power -Cursor & Select -Number PAD
-Menu -Info -Enter, Dash
-Exit -Channel Up & Down
-Guide -Last CH
EXCLUSIVE TV buttons
These buttons are for operating the TV :
-Day/Night -CC -Mute
-Aspect -Vol Up & Down -Inputs (Only if programmed,
-ANT refer to page 31).
MY Satellite RECEIVER/
SET-TOP-BOX CODE IS:
28