Hitachi P50S601 Operating Manual page 29

OPERATING THE PRECODED _
FUNCTION FOR YOUR DVD PLAYER.
This remote is designed to operate different types of
DVD players. You must first program the remote to
match the remote system of your DVD player (refer to
pages 32-33 for pre-codes).
1.
2.
Turn ON your DVD player.
To switch to DVD pre-coded mode, use the
SOURCE SELECT button on the remote control to
position the LED light to the corresponding selection
DVD.
Hold down the SOURCE SELECT button on the
remote and enter the four digit preset code that
matches your DVD player, as shown on pages 32-33.
Release the SOURCE SELECT button. The indicator
light will flash 3 times if the code was accepted.
Aim the remote at the DVD player and press the
POWER button. The remote will turn off your DVD
player when the correct four digit preset code is
entered. When this occurs, the remote control is
programmed for your DVD player. If the DVD
player does not turn off, try a different four digit
preset code.
5. The remote will now control your DVD player.
@
@m
@
@m
SOURCESELECT
:.@.@___
HITACHI
@
@
(_ PRECODED DVD Buttons
These buttons transmit the chosen precoded
DVD codes :
-Power -Number PAD
-Menu -Play, Stop, Pause,
-Info RWD, FWD, Skip RWD,
-Cursor & Select Skip FWD.
(_ EXCLUSIVE TV Buttons
These buttons are for operating the TV :
-Day/Night -CC -Inputs (Only if
-Aspect -Vol Up & Down programmed, refer
-ANT -Mute to page 31)
-Exit
MY DVD PLAYER CODE IS:
29