External Video Sources; Input Mode Selection - Hitachi 60UX58B Operating Manual

CONNECTING EXTERNAL VIDEO SOURCES
I
The exact arrangement you use to connect the VCR, camcorder, laserdisc player, and DVD player to your TV set is dependent on the
model and features of each component. Check the owner's manual of each component for the location of video and audio inputs and
outputs.
The following connection diagrams are offered as suggestions. However, you may need to modifythem to accommodate your particular
assortment of components and features. For best performance, video and audio cables should be made from coaxial shielded wire.
Before Operating External Video Source
The input mode is changed every time the INPUT button is pressed as shown below. Connect an external source to the INPUT terminal,
then press the INPUT button as necessary to view the input source. (See page 23.)
INPUT MODE SELECTION ORDER
(Antenna)
(Input)
VIDEO
I NOTE:
!
When the TV is set to VIDEO and a video signal is not received from the VIDEO INPUT JACK on the jack panel of the I
TV (i.e., VCR/laserdisc player, etc. is not connected or the video device is OFF), the set will appear to be OFF.
I
CONNECTING A MONAURAL AUDIO VCR OR LASERDISC PLAYER
1. Connect the cable from the VIDEO OUT of the VCR or the laserdisc player to the INPUT (VIDEO) jack on the TV set below.
2. Connect the cable from the AUDIO OUT of the VCR or the laserdisc player to the INPUT (MONO)/L(AUDIO) jack.
3. Pressthe INPUT buttonto viewthe programfromthe VCR or the laserdisc player. The VIDEO modedisappears automatically after
approximately eightseconds.
4. Press the INPUT button to retum to the previous channel.
TV INPUT
TERMINAL
;-VIDEO
:MONO)f,
©l
AUDIO
m
INPU'[
VCR
<*, ,,
VIDEO OUT /_JDIOOUT
I® ®1
15