Connecting External Video Sources; Input Mode Selection Order - Hitachi 46UX24B Operating Manual

CONNECTING EXTERNAL VIDEO SOURCES
e exact arrangement you use to connect the Video Cassette Recorder, Video Disc Player and Video camera to your
set is dependent on the model and features of each component. Check the Owner's Manual of each component for
; location of its video and audio inputs and outputs. The following connection diagrams are offered as suggestions.
wever, you may need to modify them to accommodate you particular assortment of components and features. For best
.'formance, video and audio cables should be made from coaxial shielded wire.
fore Operating External Video Source
e input mode is changed every time the AVX button is pressed as shown below. Connect External source to the INPUT
rninal, then press the AVX button as necessary to view the input source.
INPUT MODE SELECTION ORDER
NOTE: When TV is set to "VIDEO" and a video signal is not received from VIDEO INPUT JACK on the jack panel
of the TV (i.e., VCR/Video Disc Player, etc. is not connected or the video device is OFF), the screen will
be black.
)NNECTING MONAURAL AUDIO VCR OR VIDEO DISC PLAYER
Connectthe cablefrom the VIDEO OUT ofthe VCR or the Video Disc Player tothe INPUT (VIDEO) jackon theTV
set. (Fig. 1)
Connect the cable from the AUDIO OUT of the VCR or Video Disc Player to the INPUT (MONO)/L(AUDIO) jack.
(Fig. 1)
PresstheAVX buttonto viewthe programfromtheVCR ofVideo DiscPlayer. The videomode"VIDEO"disappears
automaticallyafter approx. 8 seconds.
Pressthe AVX buttonto return to the previouschannel.
See Below,
Video Cassette Recorder
TV INPUT
TERMINAL
INPUT
VIOEO
MONO_
AUDIO
• t, '%1_
I
VIDEO OUT AUDIO OUT
FIG. 1
2O