Connecting External Audio Sources; Connecting External Video Sources - Hitachi 57GWX20B Operating Manual

Projection color tv

Hide thumbs Also See for 57GWX20B:

Service manual (164 pages)

Training (154 pages)

Operating manual (64 pages)

Table Of Contents

Table of Contents

To control the audio level of an external audio amplifier with the remote control, connect the system as shown below.

INPUT

Stereo System Amplifier

NOTE: 1. To prevent damage to the speaker and distorted sound, set the volume control of the audio amplifier lower and adjust

the sound using the remote control of the TV set.

2. See page 41 for AUDIO Advanced Settings.

CONNECTING EXTERNAL VIDEO SOURCES

The exact arrangement you use to connect the VCR, camcorder, laserdisc player, DVD player, or HDTV Set Top Box to your TV set is

dependent on the model and features of each component. Check the owner's manual of each component for the location of video

and audio inputs and outputs.

The following connection diagrams are offered as suggestions. However, you may need to modify them to accommodate your partic-

ular assortment of components and features. For best performance, video and audio cables should be made from coaxial shielded

wire.

Before Operating External Video Source

The input mode is changed every time the VID1~VID5 button is pressed as shown below. Connect an external source to the INPUT

terminal, then press the VID1~VID5 button as necessary to view the input source. (See page 22)

NOTE:

When the TV is set to VIDEO and a video signal is not received from the VIDEO INPUT JACK on the back panel of the

TV (i.e., VCR/laserdisc player, etc. is not connected or the video device is OFF), the set will appear to be OFF.