Table of Contents
Advertisement
CONNECTING
EXTERNAL VIDEO SOURCES
The exact arrangement you use to connect the VCR, camcorder, laserdisc player, and DVD player to your TV set is dependent on the
model and features of each component.
Check the owner's manual of each component for the location of video and audio inputs and
outputs.
The following connection diagramsare offeredas suggestions.However,you may needto modifythemtoaccommodate yourparticular
assortmentof components and features. For best performance, videoand audiocablesshouldbe madefrom coaxial shieldedwire.
Before Operating External Video Source
The input mode is changed every time the INPUT button is pressed as shown below. Connect an external source to the INPUT terminal,
then press the INPUT button as necessary to view the input source. (See page 26.)
INPUT MODE SELECTION
ORDER
pnput)
VIDEO
I
NOTE:
I
When the TV is set to VIDEO and a video signal is not received from the VIDEO INPUT JACK on the jack panel of the I
"IV (i.e., VCR/laserdiso player, etc. is not connected or the video device is OFF), the set will appear to be OFF.
I
CONNECTING
A MONAURAL AUDIO VCR OR LASERDISC PLAYER
1. Connect the cable from the VIDEO OUT of the VCR or the laserdisc player to the INPUT (VIDEO) jack on the "IV set below.
2. Connect the cable from the AUDIO OUT of the VCR or the laserdisc player to the INPUT (MONO)/L(AUDIO) jack.
3. Press the INPUT button to view the program from the VCR or the laserdisc player. The VIDEO mode disappears automatically after
approximately eight seconds.
4. Press the INPUT button to retum to the previous channel.
TV INPUT
TERMINAL
m
_-VIDEO
AUDIO
INPU'I'
VCR
,F ,n,,,
I
o '; i
17
Advertisement
Table of Contents
