How To Install - Hitachi L32A403 Operating Manual

How To install Your New Hitachi LCD Television
b
Take the following precautions to prevent the LCD Television from tipping over and possibly causing injury, it is important to
mount the unit on a stable and fiat surface.
ASSEMBLY OF THE BASE
IMPORTANT: The base of the LCD TV must be assembled
prior to use.
1. Place the TV unit face down on a soft and flat surface
covered by a blanket, foam, cloth, etc. to prevent any
damage or scratches to the LCD TV.
2. Carefully align and insert the Base to the TV stand post.
3. Insert the screws included with the accessories to the
bottom of the base and tighten the base to the stand.
• Do not block the ventilation holes of the LCD
Television. Blocking the ventilation holes might
cause overheating and damage.
• In case of an abnormal symptom, unplug the AC
cord and contact 800-HITACHI.
• If you purchased a wall mount bracket, please ask
for professional installation. Do not try to instafl by
yourself.
• Instafl the unit at a proper area where it does not
expose anyone to any danger of hitting themselves
(for example their hands, head or face, etc.) against
the edge of the unit that could cause personal
injury
Caution when moving the main unit
As this product is heavy, whenever it is moved, at least two people
are required to transport it safely. Whenever the unit is moved it
should be lifted forward using the top and base on both sides of the
Television for stability.
When moving the Television, lift from the corners, then support
the top frame as shown below.
Location
Select an area where sunlight or bright indoor illumination will not
fall directly on the picture screen. If so, drapes or screens can be
used to reduce the reflection.
Also, be sure that the location selected allows a free flow of air to
and from the perforated back cover of the set. In order to prevent an
internal temperature increase, maintain a space of 10 cm (4 inches)
from the sides/back of the Television, and 30 cm (12 inches) from
the top of the television to the ceiling. To avoid cabinet warping,
cabinet color changes, and increased chance of set failure, do not
place the TV where temperatures can become excessively hot, for
example, in direct sunlight or near a heating appliance, etc.
30 cm (12 inches)
10cm ) / _ 10cm
(4 inches (4 inches)
Power Cord Installation
The power cord provided with your new LCD Television needs to be
installed correctly to avoid its disconnection when rotating the TV
on its Table Top Stand.
Located on the back of the TV there is one plastic clamp to hold the
power cord. Please follow the instructions below.
(_ Pass the power cord through the clamp and connect it to the
TV.
(_ Close the clamp to fix the power cord to the TV.
(_) All the cables connected to the TV will be held by
this clamp.
AC Wire Clamp
Securing to a Wall
1. Using metallic wire (two locations) fasten the set to the
clamping screw on the rear of the LCD TV as shown below.
2. Keep the LCD television 4 inches away from the wall, except
when mounted using the wall mount bracket, and secure to
the wall as shown below: