Connecting Internal Headers; Front Panel Header - EVGA nForce 780i SLI FTW User Manual

Connecting Internal Headers

Front Panel Header

The front panel header on this motherboard is one connector used to connect the following
four cables:
(see Table 2 for pin definitions)
PWRLED

Attach the front panel power LED
cable to these two pins of the connector.
The Power LED indicates the system's status. When the system is in S0 status, the LED is
on. When the system is in S1, S3, S4, S5 status, the LED is off.
PWRSW

HD_LED

Attach the hard disk drive indicator LED cable to these two pins. The HDD indicator
LED indicates the activity status of the hard disk drives.
RESET

Attach the Reset switch cable from the front panel of the case to these two pins. The
16
EVGA
Some chassis do not have all four cables. Be sure to match the name on the connectors
to the corresponding pins.
Attach the power button cable from the case to these two pins. Pressing the power button
on the front panel turns the system on and off rather than using the power supply button.
system restarts when the switch is pressed.
RESET