GE Monogram ZV750 Owner's Manual page 6

Controls and Features
Stainless Steel Hood
Light bulbs
NOTE:The glass cover should be removed onlg
when cool.
-&CAUTION:
Before replacing the bulb, disconnect electrical
power to the hood at the main fuse or circuit
breaker. Allow bulbs to cool before touching.
Be sure to let the light cover and bulb cool
completelg.
For safetg, do not touch a hot bulb with bare hands
or a damp cloth.
To change the light bulbs:
1. Remove the lamp lens cover bg inserting a small
flat-blade screwdriver into each of the three slots
and gentlg prging it free,
NOTE:Do not remove the outer trim ring (lamp
assemblg).
2. Grasp the bulb and pull it straight out.
3. Using gloves or a drg cloth, remove the new bulb
from the packaging. (Wearing latex gloves mag
offer a better grip.)The bulb must be the same
wattage, !20-volt, 25-watt halogen with a G-9
base. Earlg bulb failure mag occur if wattage is
too high.
4. Push the bulb straight all the wag into the
receptacle.
5. Replace the lens cover bg inserting the three
retaining tabs into the slots and pressing into
place.
NOTE:For improved lighting, clean the glass cover
frequentlg using a damp cloth. This should be done
when the hood is completelg cool.
6. Reconnect electrical power to the hood.
NOTE: Order replacement 120-volt, 25-watt
halogen bulb with G-9 base, WB25×10020.
These bulbs can be ordered from gout GEsupplier.
to remove the lamp lens cover.
Bulb
Outertrim ring
(lampassembly)
Donot remove
$ I I
Tab ---T_
ll_ _ Removable inner
__/ larnp lens cover
(J......
NOTE:Make surethe tabs are inserted
into the slots.
ONLYuse a new 120-volt, 25-watt
halogen bulb with a G-9 base.
Receptacle
Usegloves
or cloth
NOTE:Do not touch the new halogen bulb
with bare fingers. Skin oils can cause earlg
lamp failure.