GE DBVH512 Owner's Manual page 25

ge.cem
OPERATION Possible Causes What To Do
Clothes am still wet The door was opened mid-cycle. * A dr_ c)(le must be reselected each time a new load
and dryer shut off The load was then removed from is put in.
after a short time
the dryer and a new load put in
without selecting a new cycle
Small load * _'\qlen (hTing 3 items or less, choose SPEED DRY(n"
TIMED DRY
Load was already dry except * Choose
SPEEDDRYer TIMED DRYto (1I3 damp collal_
for colla_vs and waistbands and waistbands. In the turin'e, _dlen drvino "/load with
(olla_ and waistbands, choose MORE DRY.
Dryer is not level - Moxe dr_er to an even rio(n" space or ac!iust lex eling legs
as necessar} until even.
The ORYdryness level Load consists of a mixture
* _'_q_en (ombiuing
hea D and light rid)fits in a load,
was chosen hut load is of heavy and light fabrics ( hoose MORE DRY.
still damp
Exhaust system is blocked e Inspect and clean exhaust s_stem.
Cannotmake a The DRYNESS LEVEL, TEMP * This is hernial.
selection and the or OPTION that you axe
dryer beeps twice trying to select is incompatible
with the chosen dry cycle
Dryer is running hut The EXTEND TUMBLE
* This is normal.
During extended tumbling, the time
O0 is displayed in
option was chosen remaining
is not displa_ ed. The extended
tumbling
time Remaining option lasts approxJmatel} 20 minutes.
LAUNBRY PRACTICES Possible Causes What To Do
Clothes take tOOlong
Improper or obstructed ducting o Check the Installathm ]nstructhms
to make st=re the
to dry
dr_er venting is correct.
® Make sure ducting is clean, free of ldnks and
unobstrtlcted.
* Check to see if outside wall damper operates easily.
Improper sorting * Separate hea_ T items t_'om lighp, veight items (generally,
a well-s(mted washer load is a well-so,led &yet load).
Large loads of heavy fabrics * Iaige, hea\ T thbvics contain more moisture and take
(_(e beach towels) h)nger to oh> Separate la*ge, heavy tiibrics into smaller
loads to speed (hTing tiFne.
Controls improperly set
* Match control
settings to the load xou are drvin ,
Lint f'dter is fuU * Clean lint filter befin'e eve U load.
Blown fuses or tripped circuit
® Replace fuses or reset circuit breake_.
Since most
breaker dryeI_ use 2 tuses/breake_, make sure both are
operating.
Overloading/combining loads * Do not put more than one washer load in the (hyer at
a time.
Underloading ® If _ou are drvino._ onl_ one or two items, add a tow items
to ensure proper tumbling.
25