GE DBVH512 Owner's Manual page 16

Reversingthe doorswing.
STEP-BY-STEP INSTRUCtiONS (cont.)
Reassemble Door Assembly (cont.)
19.
Afier reversing door, there will be a misnmtch between the outer door and
the
innei" doox'.
Make sure that the handle part of the outer door is opposite the hinge,
as shown.
\
20. Turn the door oxer and tasten the outer door to the inner door using the
6 laroe ta )Dim, (# 10).
[ • _ scYews
Move Strike Bracket
21. Using a putt) knife or am other fiat tool, remoxe the 5 plastic screw caps
located on the dr_er where the door will be installed and install them on
the opposite side.
\
_. Switch the strike bracket and its coxer on the opposite side by remoxing the
screws; then reinstall both on the opposite side.
L
®
Tighten
Reinstall Door Assembly
23. The door is now ready to be installed on the dryer. To ease this step,
the hinge has keyholes that allow a partially fastened screw to be used
as a hook.
Partially thsten a screw to the uppermost screw hole. Hook the door on the
partially tastened screw.
Fasten the hinge by installing the other 4 screws and tightening the
partially tastened screw above.
76