GE DBVH512 Owner's Manual page 3

ge.com
%
PROPER INSTALLAtiON
This dryer must be properly installed and located in accordance with the Installation Instructions
before it is used. If you did not receive an Installation Instructions sheet, you can receive one by
visiting ge.com, or by calling 800.GECARE$ (800.432.2737).
[] Properly ground dryer to confi}nn with all
governing codes and ordinances. Follow details
in Installation Instructions.
[] Install or store where it will not be exposed to
temperatures below fi'eezing or exposed to
the weather:
[] Connect to a properly rated, protected and sized
power supply circuit to
a_)id
electrical overload.
[] Remove tile colored protective film l/"om both
tile control panel and tile doo,:
[] Remo\v all shaq) packing items and dispose
ot all shipping materials properly.
[] DO Ilot FeIllove
tile vent protector ,q'om tile
back of the (hwel:
[] Pull the pxotector out and down to its lowest
position and connect the exhaust duct to the
(h'vel: Tile lowered protector will prevent tile
duct i]'om getting crushed.
Exhaust/Ducting:
_] Drvel_ MUSTbe
exhausted to tile outside to
prevent l'u'oe, _ amounts of moisture and lint
fl'om being blown into the room.
] * . . it
[_ t_se ()Ill) ngld metal or flexable metal 4
diameter duct\_ork inside tile (h'_er cabinet or
fkw exha usting to tile (_utside. USE OF
PLASTIC
OROTHER COMBUSTIBLE OUCTWORK CAN
CAUSE A FIREPUNCTURED BUCTWORK CAN
CAUSE A FIREIF IT COLLAPSES ORBECOMES
OTHERWISE R ESTRICTED IN USEOROURING
iNSTALLATION.
For complete details, fbllow tile Installation
Instructions.