GE JSP46 Owner's Manual page 29

www.GEAppliances.com
Possible Causes What To Do
The oven temperature is
too high to set a self-clean
operation.
Oven controls improperly set.
• Allow the oven to cool to room temperature and
reset the conu'ols.
• See the Using the self-cleaning ovensection.
This is the sound of the
metal heating and cooling
during both the cooking and
cleaning functions.
• This is normal.
Excessive soil.
• Press tile CLEAR/OFF pad. Open tile windows to
rid the room of smoke. Wait until the LOCKEDlight
goes off. Wipe up the excess soil and reset the clean
cycle.
Oven too hot.
• Allow tile oven to cool below locking temperature.
Oven controls not properly set.
• See the Using the self-cleaning ovensection.
Oven was heavily soiled. • Clean up hea W spillovers before starting the clean
cycle. Heavily soiled ovens may need to self:clean
again or for a longer period of time.
The self-clean cycle has been • Close the oven door.
selected but the door is not
closed.
The oven door is locked • Press the CLEAR/OFF pad. Allow tile oven to cool.
because the temperature
inside the oven has not
dropped below the
locking temperature.
Youhave a function • Press tile CLEAR/OFF pad. Put the oven back into
error code. operation.
If the function code repeats. • Disconnect all power to tile range fbr at least 30
seconds and then reconnect power. If the fimction
error code repeats, call fbr set-vice.
29