GE JGP990 Installation & Owner's Instructions page 28

Installation Instructions
INSTALL THE COOKTOP
[] INSTALL THE COOKTOP
I,ower the cooktop into the com_tertop opening,
guiding it into position.
[] SECURE THE COOKTOP
Tighten the tie-down bolts to secure the cooktop
to the cotmter. For cotmtertoi)s less than l" thick,
secm'elv attach filler blocks of wood to the
bottom of the cotmterto I) where the tie-down
bolts will be tightened.
Fillerwood block Tie-down
for countertops bolt througl_
lessthan 1" thick cook@ tab
(_¢oeoe
eee_
oee®®
[] OPTIONAL: ATTACH A BLOWER
TRANSITION DUCT
If using 6" round standard ductwork, attach a
blower transition duct. This 3¼" x 10" rectangle
to 6" rotmd transition duct is awfilable at wmr
local building supply store.
Screw
(onotherside)
Install the transition duct to the blower outlet.
Secm'e all joints with duct tape to assm'e an
airtight seal.
28
[] CONNECT THE DUCTWORK
Connect the ductwork prepared earlier to the
blower transition duct.
[] ELECTRICAL CONNECTION
Electrical requirements:
120wolt, 60-Hertz, individual, properly grotmded
branch circuit protected bv a 15-amp circuit
breaker or time-delay fllse.
GROUNDING
IMPORTANT: (Please read carefully.) FOR
PERSONAl, SAFETY, THIS APPI,IANCE MUST
BE PROPERI,Y GROUNDED.
The power cord of this appliance is equipped
with a three-prong (grounding) plug which mates
with a standard three-prong grotmding wall
receptacle to minimize the possibility of electric
shock hazard fl'om this appliance. The customer
should have the wall receptacle and circuit
checked bv a qualified electrician to make sm'e
the receptacle is properly grotmded and has
correct polarity.
Where a standard two-prong wall receptacle is
encotmtered, it is the personal responsibility and
obligation of the customer to have it replaced
with a properly grotmded three-prong wall
receptacle in accordance with the National
Electrical Code,
Do Not, Under Any Circumstances, Cut Or
Remove The Third (Ground) Prong From The
Power Cord.
Do not use an extension cord with this appliance.
Plug the power cord into an approxed wall outlet.