Installation Instructions
[]
PLUG IN THE REFRIGERATOR
Arrange
the
coil
of tubing
so that
it does
not
_ibrate
against
the
back
of the
refrigerator
or against
the
wall.
Push
the
refi_gerator
back
to the
wall.
START THE ICEMAKER
On power
switch
models,
set the icemaker
power
switch to the I (oil} position.
On feeler
arm
models,
move the feeler
arm to the ON (down)
position.
The
icemaker
will not begin
to operate
until it reaches
its operating
temperature
of 15°F (-9°C)
or below.
It will then
begin
operation
automatically.
Powerswitch model
,7
//
//
.... '_r--.. Feeler Arminthe
STOP (up)position
in
the ON (down)position
Feelerarmmodel
NOTE:
In lower water
pressm'e
conditions,
tile
water
xalxe max tm'n on up to 3 times
to delixer
enouoh
water
to tile icemaker.
REVERSING THE DOOR SWING
IMPORTANT
NOTES
\_l/en
re\'e_ing
tile door swing:
• Read tile instructions
all tile way through
beflwe
starting.
• Handle
parts
careflflly
to avoid scratching
paint.
• Set screws down by their
related
parts to avoid using
them
in the wrong
places.
• Provide
a non-scratching
work sm'lace
for
the doms.
IMPORTANT:
Once wm begin,
do not move the
cabinet
tmtil doo>swing
reversal
is completed.
These
instructions
are fiw changing
the hinges
ti'om
the right side to the left side--if
you ever want to change
the hinges
back to the right
side, follow these
same
inst_ uctions
and reverse
all references
to left and fight.
TOOLS REQUIRED
Phillipsscrewdriver
Maskingtape
5/16" hex-head
socketdriver
T20 or T25 Torxdriver,
(Needed for some models)
Putt_
kni[e or thin-
blade screwdrix er
5/16" open-end
wrench
/7
Need help?
Do you have a question about the GTS18FCSARWW and is the answer not in the manual?