GE GTS18FCSARWW Owner's Manual And Installation Instructions page 20

Installation Instructions
B REVERSING THE DOOR SWING
(CONT.)
[] REVERSING THE HARDWARE
4.1 Remove tile base orille (if' _our refrigerator has
one) b} pulling it straight out.
4.2 Moxe tile 1)ottmn hinoe_ bracket (and shim glued
to it) and plastic washer from tile right side to tile
leit side.
Plastic Plastic
Washer Washer
Hinge---> --_
Bracket Hinge
Bracket
Modelswith a hingebracket Modelswith a hingebracket
that has 2 screw holes, that has 4 screw holes.
Switchthe hinge pinto the
oppositeside of the bracket.
4.3 Interchange hinge (and tile shim glued to it) and
screws at top right with screws at top left of cabinet.
Do not tighten screws on hinge side at this time,
Installingthe hingeon the left. Installingthe hingeon the right.
NOTES:
• Some hinges have flmr holes. Which holes you
use fi)r installing tile hinge depends on which
side you install tile hinge.
• Tile outer
edge of tile hinge should be parallel
to tile edge of tile case ti)r correct installation.
I
[] REVERSING THE DOOR HANDLES
5.1
Plug_
Transfer fresh food door handle
5.1.1 Remove tile handle plug using a
tape-tipped putty knife under tile edge,
and reil/ove tile screw tlnderneath.
Remove tile two screws holding tile
handle to tile top of tile door.
5.1.2 Remo_e tile handle.
I
5.1.3 Remo_e tile screws fl'om tile right edge of tile
door top and insert them into tile handle screw
holes on tile opposite side.
5.1.4 With tape-tipped putty knife or thin-blade
screwdriver; pry out tile plug button from tile
hinge hole on the left side of the door and
insert it into the hole on the opposite side that
was vacated by remowfl of tile top hinge.
Plug Buzp
20