GE GTS18FCSARWW Owner's Manual And Installation Instructions page 6

About the fresh foodcompartmentshelves.
Shelf supports at various levels allow you to custom-space your shelves. Not all features are on all models.
Half-Width Shelves
[T]]qlt uo
One end of the shelf rests on a molded
side-wall support; a bracket on the other
end hooks into a track on the rear
cabinet wall.
To remove, lift the shelf up at fl'ont,
then
off the SUl)l)ort and out of the track.
To replace, select desired shelf height.
With shelf ti'ont raised slightly, hook the
bracket's top lug into the track, then
lower the shelf onto the SUl)port.
NOTE:Theshelf to the @t of the track/s
designedto hookintothe @t-hand dot,
the shelf to the left isdesignedto hook
intothe left-handslot.
Full-Width Shelves
Some models have a steel wire sliding
sheik a stationary tempered glass shelf or
two steel wire stationary shelves. These
shelves can be moved to another place
in the ti'esh ti)od compartment.
The flfll-width sliding shelf has stoi>locks.
When placed correctly on the shelf
SUl)ports, the sh elf will stop beti)re coming
completely out of the refl'igerator and will
not tilt when you place toed on it or
I'eI/lOVe
ti),)d
ti'OIll
it.
To remove the full-width shelves, lift the
rear of the shelf and pull forward.
Toremove a full-width shelf when the fresh
food compartment door cannot be opened
fully, lift the rear of the shelf, pull
ti)rward and down, tilt the shelf and
take it out.
Spillproof Shelves (onsomemodels)
Spillproof shelves have special edges
to hel I) prevent spills from dripping
to lower shelves. To remove or replace
the shelves, see the above inst_ uctions.