Using The Dishwasher - GE Monogram ZBD6800 Owner's Manual

Using the dishwasher
Dishwasher
Lighting
b?atures (on
some models)
Interior Lights (on some models)
Tile interior Xenon lights provide better
visibility tot loading and unloading. They come
on when tile door is opened and tm'n off when
the door is latched. The lights will turn off atter
15 minutes if tile door remains tmlatched. To
turn tile lights back on latch and reopen tile
dooI;
End-of-Cycle Indicator Light (on some models)
Tile end-ot:cvcle indicator light is located on
tile right side of tile dishwasher, above tile
handle. This light comes on when the selected
cvcle and enhancements are complete. Tile
light will stay on tmtil the door is opened. The
dishes may be rein oved at any time.
Do not attempt to replace tile bulbs. If light
bulb replacement is necessary, please contact
the GE Answer Center tot service by calling
1-800-626-2000.
Note that tile high-efficiency thn will rtm quietly
fi)r 30 minutes to 4 horn's (depending on tile
selected cycle) after tile end-ot_cvcle indicator
light is ilhm/inated to continue drying tile
dishes. Opening tile door and pressing any
keypad will stop tile tim.
Waler
7bmperature
Tile entering water must be at least 120°F
(49°C) and not more than 17)0°F (66°C), ti)r
efli_ctive cleaning and to prevent dish damage.
Check the x_z_ter temperatm'e with a candy or
illeat thermollletei; Wtli'n on tile hot water taucet
nearest the dishwasher, place tile thermometer
in a glass and let tile water run continuously into
the glass until the temperature stops rising.
Use a Rinse
Agent
A rinse agent improves (h y peril)finance,
reduces spots and prevents new fihn build-u I)
on yore" dishes, glasses, flatware, cookware
and plastic. Jet-Dry ® and Cascade Rinse Aid ®
are recommended rinse agents lot Monogram
Dishwashers.
Tile rinse agent dispenser holds 3.5 oz. of rinse
agent. Under nom/al conditions, this will last
approximately one month. Try to kee I) it flfll,
but do not overfill.
To fill tile rinse agent dispenser; make sm'e tile
dishwasher is flflly open.
Tm'n tile dispenser cap to tile left and lift it
out. Add rinse agent tmtil tile indicator window
shows fifll.
Clean up any spilled rinse agent with a damp
cloth. Replace the dispenser cap.
The amo/mt of rinse agent released into the
final wash can be a(!justed. Tile tactory setting
is at tile midpoint. If there are rings of calcimn
(hard water) spots on dishes, try a higher
setting. If there is toaming, use a lower setting.
To a(!just the setting, remove the dispenser cap;
then turn the a(!juster cotmterclockwise to
increase tile amotmt of rinse agent.
Rinseagent
adjuster