I,Fit-Off Oven Door - GE JDP39 Owner's Manual

ge.com
\, /i"
Do not rub or clean the door gasket--
it has an extremelylow resistanceto
abrasion.
If you notice thegasket becomingworn,
frayedor damagedin any way or if it has
becomedisplacedon the door,you
shouldhave it replaced
Cleaning the Oven Door
Toclean theinsideof thedoor:
iii_ii_ii_i_iiiiiiii
{{{iiiiiiili
Because the area inside the g_tsket is
cleaned during the self-clean cycle, you
do not need to clean this by hand.
The area outside file gasket and
file door liner can be cleaned Mth a
soap-filled or plastic scouring pad,
hot wamr and dem_gent. Rinse well
with a vinegar and wamr solution.
Toclean theoutside of the door'.
Use soap and wamr to flloroughly
clean file rap, sides and flont of die
oven dooL Rinse well. You may also use
a glass cleaner to clean file glass
on the outside of the dooL Do not let
water drip into the vent openings.
If any stain on the door vent tlq_nlis
persistent, use a soft abrasive cleaner
and a sponge-scrubber for best results.
Spillage of marinades, fluitjuices,
tomato sauces and basting mamriMs
containing acids may cause
discoloration and should be wiped
tap immediately. When surface is cool,
clean and rinse.
Do not use oven cleaners, cleaning
powders or hm_h abrasives on the
outside of the dooL
¸¸¸¸¸¸¸¸¸¸/5¸¸
Hingelock
Pull hinge locks down to unlock.
ii iil
Removal position
'/U
/
Lift-Off Oven Door
Thedooris veryheavy. B e carefulwhen
removing and liftingthe door.
Toremovethedoor:
%
%
Fully open the dooL
Pull the hinge locks down toward
the door flame, to the unlocked
position. A tool, such as a small
fiat-blade screwdriver; may be
required.
Firmly grasp both sides of the door
at the top. D0not riftthe door by the
handle.
Close door to file door removal
position, which is hMf_,vaybetween
the broil stop position and flail),
closed.
[_ I,iff door up and out until the hinge
arm is clear of the slot.
Toreplace the door:
Firmly grasp both sides of the door
at the top. DOnot rift the door by the
handle.
%
%
With the
Bottom
door at the
edge
ofslot
same angle as N
tile removal
position, seat file
notch stop of
the hinge am1
into the bottom
edge of the hinge slot. The notch in
the hinge ann must be flflly seared
into the bottom of the slot.
Hinge arm
Fully open the door until it is
parallel to the flOOLIf the door will
not filly open, the notch stop is not
seared correctly in the bottom edge
of the slot. Repeat stop 2 if
necessary.
Push the hinge locks tap against the
flont flame of the oven cavib_ to the
locked position.
arm
Hinge
Push hinge locks up to lock.
(;lose the oven dooL
79