Wash Cycle; On The Appliance; Change The Program - Danby Silhouette DDW1806BSL Instruction Manual

WASH CYCLE TABLE
Heavy
Normal
Economy
Rinse
Glass
Rapid
Soak
[2'
55(:
(
! I
45/2
Z
5
i12
,(
I:{
1!51
For heavily soiled loads,
such as pots, pans, casserole
dishes and dishes with dried
food.
For normally soiled loads,
such as pots, plates,glasses
and lightly soiled pans.
Standard daily cycle.
For lightly soiled loads,such
as plates,glasses,bowls and
lightly soiled pans.
Pre-rinse (45 ° C)
Wash (65 ° C)
Rinse
Rinse(70°C)
Drying.
Pre-rinse
Wash (55 ° C)
Rinse
Rinse(70°C)
Drying.
Wash (45 ° C)
Rinse
Rinse (70 ° C)
Drying.
4/20 gr.
4/20 gr.
20 gr.
For dishes that need to be
rinsed and dried only
Rinse
Rinse (70° C)
Drying.
A shorter wash for lightly
soiled loads that do not need
drying.
For lightly soiled loads, such
as glasses, crystal and fine
china.
Wash (45 ° C)
Rinse
Rinse (65 ° C)
Drying
Wash (35 ° C)
Rinse
Rinse
15 gr.
15gr.
Pre-wash of dishes, pots and
pans while waiting for the
load to be completed after the
subsequent meal.
Pre-rinse
TURNING ON THE APPLIANCE
Starting a wash cycle...
] • Draw out the lower and upper basket, load the dishes and
push them back. It is recommended to load the lower
basket first, then the upper basket.
Add Detergent and rinse aid:
(See Page 5)
_ Ensure the door is properly closed.
NOTE:
A click will be heard when the door is closed
properly.
Press the ON/OFF button.
According to the soil level, choose the desired program
by pressing the program selection button.
Press the Start/Pause button to start the washing.
Press the ON/OFF button at the end of washing. Open the
door of the dishwasher after waiting 30 minutes.
Change the Program
It is possible to change a program selection anytime during
operation, by following the below steps;
{! Press the Start/Pause button to stop the washing program.
Press the selector button to select the desired program.
(the red pilot light will illuminate below the selection made).
{3 Press the Start/Pause button to re-start the dishwasher.
At the end of the wash
At the end (completion) of the regular wash program, the
time display will flash accompanied by an audible signal
for approximately 8 seconds.
NOTE:There is "no" audible signal at the end of the wash
program when using the "delay" start program. Only the time
display will flash.
NOTE: If the door is opened during operation, the
dishwasher stops automatically and will re-start automatically
when the door is closed. There may be a slight delay of several
seconds before the machine starts. This is normal.
€,
ix
4"
2_
4_
i:
3