Welcome Welcome to the Danby family. We are proud of our quality products and we believe in dependable service. We suggest that you read this owner’s manual before plugging in your new appliance as it contains important operation information, safety information, troubleshooting and maintenance tips to ensure the reliability and longevity of your appliance.
Important Safety Information READ AND FOLLOW ALL SAFETY INSTRUCTIONS GROUNDING INSTRUCTIONS SAFETY REQUIREMENTS This appliance must be grounded. In the event of an • Children should be supervised to ensure that electrical short circuit, grounding reduces the risk of they do not play with the appliance. electrical shock by providing an escape wire for the electrical current.
Page 4
INSTALLATION INSTRUCTIONS ACCESSORIES 1. ST3.5*9 screws for the installation brace (x2) 2. ST3.9*13 screws for the kick plate (x2) 3. ST4*14 screws for the installation brace (x2) 4. Condensation strip 5. Installation brace (x2) 6. Adjustment caps (x2) 7. Kick plate 8.
INSTALLATION INSTRUCTIONS Connecting the hot water line Run the hot water line through the channel on the bottom left side of the appliance. Make sure the hot water line is not twisted and then connect it to the appliance using an elbow joint. Use Tefl on tape or sealing compound on the connection to avoid leaks.
Page 6
INSTALLATION INSTRUCTIONS WIRING CONNECTION INSTRUCTIONS 1. Junction box 2. Power cable Before connecting the power cable to the 3. Black to black dishwasher, make sure the circuit breaker is off. 4. White to white 5. Green to green (ground to ground) In the junction box located at the front bottom right 6.
INSTALLATION INSTRUCTIONS LEVELING INSTRUCTIONS Ensure that the appliance is level before placing it into the enclosure. The rear foot can be adjusted from the front of the dishwasher by turning. Use a fl at screwdriver to adjust the front feet until the appliance is level.
OPERATING INSTRUCTIONS CONTROL PANEL 1. Power button: Use to turn the appliance on or off. 2. Handle 3. Programs: The light will illuminate to show which program has been selected. A: Heavy wash B: Normal wash C: ECO wash D: Glass wash E: Rapid wash F: Rinse 4.
OPERATING INSTRUCTIONS WASH CYCLE TABLE Press the program button to select the desired wash program. Note: Cycle times are approximate and will vary based on the options selected. Program Cycle Description Cycle Breakdown Running Time Water Use Heavy For heavily soiled loads Pre-Wash 155 minutes 21.5 litres...
OPERATING INSTRUCTIONS LOADING THE DISHWASHER LOADING THE UPPER BASKET • Scrape all dishes to remove any large food The upper basket is designed for cups, glasses, residue before placing in this appliance. small plates, bowls and plastic items that are •...
OPERATING INSTRUCTIONS DETERGENT DISPENSER RINSE AID DISPENSER The detergent dispenser must be fi lled before the Rinse aid can be used to prevent water droplets or start of each wash cycle. Add the detergent just streaks from forming on dishes. The rinse aid will be before starting the wash cycle.
OPERATING INSTRUCTIONS CARE & MAINTENANCE STARTING A WASH CYCLE CLEANING 1. Load the dishwasher as per the loading • After every wash, leave the door slightly open so instructions. that moisture and odors are not trapped inside the appliance. 2. Add detergent and rinse aid as required. •...
CARE & MAINTENANCE FILTER SYSTEM SPRAY ARM The fi lter system removes food particles from The spray arm can be removed from the appliance the wash water and traps them. It is highly by pulling gently upwards. Rinse the spray arm with recommended to empty and clean the fi...
TROUBLESHOOTING Danby Consumer Care: 1-800-263-2629 Hours of operation: Monday to Thursday 8:30 am - 6:00 pm Eastern Standard Time Friday 8:30 am - 4:00 pm Eastern Standard Time Information in this manual is subject to change without notice. PROBLEM POSSIBLE CAUSE No power •...
Page 15
Nothing within this warranty shall imply that Danby will be responsible or liable for any spoilage or damage to food or other c...
Page 16
MODEL DDW1804EW DDW1804EBSS Printed in China Danby Products Limited, Guelph, ON, Canada N1H 6Z9 Imprimé en Chine Danby Products Inc., Findlay, Ohio, USA 45840 Impreso en China...
Need help?
Do you have a question about the DDW1804EBSS and is the answer not in the manual?
Questions and answers